Chalk up another one here.
Barb Siddiqui
>And I was told by those more experienced: "You may replace it, but you'll probably keep it always." To my mind, That is a good purchase.
Knowledge You Can Build On — Est. 1998
Chalk up another one here.
Barb Siddiqui
>And I was told by those more experienced: "You may replace it, but you'll probably keep it always." To my mind, That is a good purchase.
ShopSmith, Nova Mercury, and Jet Mini (non-vs)
RevDoug
>
2 x Silverdrive Stateman, PM3520, 2 x Hegner
CuttingCrew
>
Jet1642, 6 ft. W&H Beheomuth, delta midi NM
dick mcneill
>
Re: Chalk up another one here. And another here!
Carol from AZ
>
Poolewood Euro 2000
Ellis Walentine
>Seems that Grumbine and I are the lone Poolewood guys here, though I don't think he has weighed in yet. I bought it because my old shop burned down and took my Brodhead Garrett J-Line and my old Delta 1236 with it.
I considered a One-way but because of my back problems, I opted for the Poolewood, which has a head that swivels to any position for hollowing.
I like having infinite variable speed control, although I was happy enough with the ol' J-Line's Reeves drive. I don't like the fact that the motor is integral with the headstock spindle, ergo, no chance of using knockout rods or through-the-spindle vacuum rigs.
On the plus side, this lathe has a ton of power. It's not as nicely finished as a Oneway, but that hasn't made a difference to me, survivor that I am.
Too bad Poolewood is history. I hope I never have trouble with my lathe. It could be tough to get service. I particularly worry about the electronic variable speed controls. I'm counting on David Ellsworth to help me fix any problems that arise. Meanwhile, I love this lathe.
Ellis Walentine, Host
Jet 1642 and Delta Midi
Dominic Greco in Richboro PA
>
Re: Karle Spinshop
wes bischel
>Ken,
I've got one as well. Stout little bugger! Mine is still set up for spinning - I'll learn one of these days!
Wes
Re: Lathes
Jerry Glaser
>Since 1955 an Oliver 12" swing lathe that I purchased at an auction of used school equipment for $60.00. Was made in the 1929's.
Re: Lathes
MountainMan
>JET mini and JET1236
Re: Lathes
Charlie Anderson
>Powermatic 3520B
Re: Lathes
Charles Bjorgen
>I purchased the Vicmarc VL200 shortbed about four years ago because it fit the available floor space in my basement shop. Later, I also bought the Nova Mercury to have a lathe I could take to other locations.
Re: Lathes *LINK*
Vincent Welch
>Oneway 1640 with Outboard attachment and a jet minilathe for small work.
http://vincesWoodNWonders.com
GI 25-650 and CTC 1234
Ed in Leaside (Toronto, Ontario)
>Both have been stretched.
The GI is 16x43 plus 62.
The CanTire lathe (HF equiv) was plus 48 but I've cannibalised most of the metal parts for the GI. It will be redone with a wood based sub-bed.