Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Overwhelmed by options for chucks

Posts

Re: Overwhelmed by options for chucks

#26

Re: Just remember Joe...

John Lucas

I'm with Bill, I'm on the 10 step program to greatness. :)

Re: Overwhelmed by options for chucks

#27

Any question about tools gets a lot of hits...

Dick Coers

...try asking about choosing carbide insert tools or HSS. LOL

Re: Overwhelmed by options for chucks

#28

No esoterica for me, can anyone 'Spain

Joe shelton

Why my manual shows the drive center installed thru the faceplate?

Does the faceplate act like a flywheel?

Joe

Re: Overwhelmed by options for chucks

#29

Re: No esoterica for me, can anyone 'Spain

John Lucas

No they just didn't take the time to remove the faceplate. A lot of faceplates don't have a hole big enough to install the drive center through the faceplate. It also might get in the way with some cuts if your turning a spindle close to the drive center.

Re: Overwhelmed by options for chucks

#30

Re: Overwhelmed by options for chucks

SergioV

I have a Vicmarc 120, a Oneway stronghold and a oneway chuck the one with the tommy bars. I use the small one almost only the tail stock and I found it excellent at this. Between the two big ones I really believe the Vicmarc is superior for ease of use (the ex key is so easier) the pinion that can easily be changed if needed and the sealed back. Dust in the Stronghold is a nuisance just to save a few bucks. If I'll buy another chuck it will definitly be a Vicmarc.