Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Band saw kick-back

Posts

Re: Band saw kick-back

#26

Re: Band saw kick-back

Bruce McCrory

Robo, I know your feelings. It is really exasperating to not have a cut-and-dried solution. Cutting cedar has not had the violent reactions I experienced when cutting doug fir. That said, DF does have extreme density-hardness variation between early and late wood, which makes a perfect scene for variable response.

Mr. Hyde, in light of your experience, I must recheck the weld alignments. As noted above, to Robo, the blade might just be plowing through the softer grain and be hiding that very problem.

Thanks,

Re: Band saw kick-back

#27

I suspect there is more hook than before.

Keith Newton

The extra hook can pull itself ahead faster than you are feeding, especially if you try cross-cutting, or maybe had some upward slant in grain when ripping.

I think I would try tilting the top wheel back a bit more to make the blade tighter against the thrust bearing.

I'm wondering if the jolt may come from the extra surge forward of the blade, pulling down the top wheel, compressing the spring, or if the motor is loose, it could climb the belt, then fall back.

Re: Band saw kick-back

#28

Re: Band saw kick-back

Kevin Stanbary in McHenry, IL

A little late to this party, but thought I would share a recent experience of mine. I have a 30-odd year old Sears Craftsman 12" bandsaw that's probably similar to yours...

Recently had a "kicking" problem similar to what you described but usually only with thicker stock. After spending some time going through the saw, found that the bearings had started to go for the bottom wheel. There was no noticeable problem unless the saw was under load. Ordered new bearings and all was better.

Good luck!

Re: Band saw kick-back

#29

Re: Band saw kick-back

Bruce McCrory

Kevin, I have a gut feel that there are several problems, hidden during the easy life I gave it for ten years--balsa--and only loading the machine caused them to surface.

I may send it back to pseudo-scroll saw duties and bring in a bigger brother. But that means more expense than just saw. We will need more power service and substantial upgrade to house power. A new saw is the least costly part.

I just discovered that the bandsaw, vacuum, and AC are a bad combo. I can't justify an electrical tuneup for only a saw when my wife's iron blows a circuit every time it and the microwave are on at the same time.