Or worse- hop off the hinge and not fall at all!
steven antonucci
I had the privelege of learning to fell trees the hard way-with standing dead hemlock that were at a point of serious decay. Looking back at it, I should have known better, but I didn't. Experience is what you get right after you needed it...
I had this one hemlock that was severely decayed, and probably 18" in diameter with a 14" bar on my saw. Nowhere to cut a hinge, as the outer wood could be kicked off of the tree 4" deep. This 30" tree was probably being held up by a 6"x6" center post that I couldn't see through all of the punky outer wood.
Well, I cut it and it twisted off the stump and landed right next to it, but didn't fall. I ended up cutting it 3 more times to get it all on the ground, and each cut was an adventure. If I was going to do it today, I would have cleared off the punky wood, and taken it down properly (wedges, ropes, etc...)
I highly recommend that folks talk to "tree guys" whenever you get a chance and observe what they do. I've learned tons from them, and they are a great resource.