Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Tree felling technique *LINK*

Posts

Re: Tree felling technique *LINK*

#26

Brad Vietje

Re: The hinge . . .

Brad Vietje

Folks,

A plunge cut can be mastered with a little practice. I have not gone to a lumberjack class like Mike, but it seems like a good investment. I'd agree with Russ that it would be a LOT better to be taught this sort of thing than to just try it because you saw it on YouTube!

If you remove a wedge in the direction of the fall, then make a plunge cut through the traditional hinge area, before any back cut for stability, you are left with two hinges -- one on each side. You an then cut through both, slowly, to allow the tree to fall in a controlled fashion. Sometimes one tree will fall against another, and it would be ideal if you could get it to turn, or even spin as it falls to roll off the other tree... This can sometimes be accomplished by cutting the two resulting hinges unevenly, so one gives way before the other, causing the tree to twist in a neat pirouette as it starts to fall, and avoid a nasty hanging "widow-maker".

A local forester/logger came over last fall to help with a huge old Sugar Maple that split in a storm, and involved a number of smaller Black Cherries and Yellow Birches --- all on a steep bank. This young fellow was a master with his "Husky", and was able to spin one 50' Yellow Birch and have it roll off a White Ash we hoped to preserve without damage, and lay it right where he wanted it. He made it look like a well-practiced dance step.

One thing I just won't do is try to fell trees when the wind is not cooperating. The notion that you can push a tree against the wind with a tractor has killed more than one person around here in just the past year or so -- don't forget that the tree may weigh a LOT more than the tractor (truck, Jeep, ATV, etc...), and when you add in the force of the wind, you have a recipe for some real stupidity -- possibly a Darwin Award.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Tree felling technique *LINK*

#27

Re: The hinge . . .

Doug Trembath

I agree there, Doc...

I have an old friend that has downed trees for thirty some years, and has some wonderful stories to tell. One that sticks in my mind was a tree that spun 360 degrees before falling exactly where he wanted it. Go figure!

All in all, felling a hardwood tree is not a beginner's task, nor one to be taken lightly. Having done it many times, I still get in situations I can't control, so if they're too close to something valuable, I call on my friend for help and advice.

On the plunge cut issue, guys, I never knew you shouldn't do it, it came naturally to me, and I use it a lot, for a lot of reasons. Experience and fluency with any tool will help you understand what it'll do in various circumstances...

Doug Trembath

Re: Tree felling technique *LINK*

#28

Re: The hinge . . .

bill crommett from Seneca

To those who have had a tree fall over backward:

Once, while clearing off a wood lot ahead of the gravel grinder crew, I was felling a big red oak that wanted to fall over backwards. I had just gotten my wedge in place and retrieved my saw when a sudden breeze came up and pushed the tree over backwards. It wouldn't have been too bad except that this tree was about ten feet from the edge of gravel excavation. When the major part of the tree went down into the old gravel pit, the butt log bounced about twenty feet in the air and came down inches from my face. That was 35 years ago, and I am still alive but far more cautious. In those days I had far better bowel control than I do now, so I went on cutting trees instead of heading home.