Response and request for follow-up
Wiley Horne--So. Calif.
WOW! What a group of great ideas! There are several reasonably good ways to go. If anyone comes up with something more, please add it. I would like to reply collectively at this juncture, except to Kevin Adams, which is in the text above.....
1. Recessed pulls. This is a strong idea. I should have mentioned that the drawer front is 3/16" thick, so the recessed pulls would involve adding some meat behind the recesses and encumbering the useful volume. I think the idea would work well, had I planned on it from the beginning, and left enough meat in the drawer front to execute it.
2. Drop pulls. Another strong idea, with or without the drops falling into a shallow recess. The tradeoff is whether to break the grain flow across the front, or not.
3. Pierced front. This seems like the most Krenovian and direct solution. It could be fingerholes, or some sort of lattice pattern. The question is whether this feature is better than the unbroken grain lines.
4. Soft solutions. Steven Shepherd mentioned this. Leather or fabric or knotted rope. Anecdote: I received a gift from Japan once, which came in a paulownia box, and the box was pierced with small holes to allow a silk belt to wrap over and tie the top down onto the box. I found the effect to be stunning. So the idea of threading a kimono tie or similar through the drawer front as a pull is attractive. If done well, it is also a way to 'go with the flow'.
5. Darrell's grandfather's 'key' solution. This is immensely practical, and requires only an escutcheon on each side. Only issue is whether to do anything to the front.
6. Spring and catch. Several folks recommended this, and this is what I would like to try. Because it leaves the grain flow unbroken across the front.
Request for followup help: But I can't figure out an efficient mechanism for doing the spring and catch. Let's say you have a coil spring or a wooden spring mounted at the rear of the box, behind the drawer. Or there could be a pair of wooden springs more toward the front, exerting pressure on each side of the backside of the drawer front. But where is the catch-and-release mechanism? Do you have a mechanical catch like a spring-loaded button right at the foot of the drawer front, which could be pushed down to let the spring push the drawer out? Or is the catch-and-release somehow integrated with the spring itself?
Again, all ideas (and counter ideas too!) are most welcome and needed!
Wiley