Re: Comment, request, and news
Derek Cohen (in Perth, Australia) Also, I saw you post an approach to layout for forming an overstuffed infill (flush with the outer sides) in the past. I thought it was clever, but now can't remember it. Do you know the link for that, too, perhaps?
>Could you post the link of the original show and tell on this plane of yours. I think I saw it and read how you made the knurled screw, but have forgotten. I didn't remember the piece of brass(?) filling the blade slot. From your pics today, I'm curious now how it's involved in clamping the blade to the bed. Finally, today I realized that fitting the bed infill to the bosses and projections of the inner body casting would be a challenge, and I wonder how you dealt with them. I'm guessing it's all in your original post.
Thank you Bob for your encouragement. Keep an eye out on eBay for my forthcoming offerings of retreaded Stanley infills! 
There are three articles are on my website (link to website below). These are:
"Shopmade Tools":
Making Lever Caps and Lever Cap Screws in the Backyard
A Galoot�s Infill Smoother
http://www.inthewoodshop.com/ShopMadeTools/A_Galoots_infill_smoother.html
Essentially, all projections inside the shell were ground out to fit the infill. The blades' slot was filled with brass by filing it fractionally too large, leaving it in the freezer to shrink, and eventually force-fitting with a big hammer. The brass thawed and expanded to create a solid connection.
The third article you refer to was a restoration I made to a Spier smoother. I did not know it was a Spier at the time I purchased it, and this article chronicles the discovery and research on the OldTools List.
http://www.inthewoodshop.com/ToolRestorations/Renovating%20an%20Infill%20Smoother1.html
I must say I am very tempted to rebuild the Spier to meet more closely with the original design. I was having a bit of fun because the plane had zilch collector value (all that was original was the shell and the levercap). So it came out a bit OTT.

Nevertheless I did demonstrate making templates to recreate the stuffing for the plane, which is what I think you remember.
Regards from Perth
Derek
p.s. look out for the #4 infill on eBay




