Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

saw sharpening device

Posts

Re: saw sharpening device

#76

Back side bevel

Warren in Lancaster, PA

>Sloping the file (or tilting the saw away from you) allows you get a sharp front bevel without making a sharp point on the tooth. Holly thinks the sharp point would be more vulnerable in hardwood. So tilting gives the front bevel angle of more fleam with the tooth strength of less fleam.

Re: saw sharpening device

#77

That nails it

Wiley Horne--So. Calif.

>Warren,

I think I get it now. Keep the acute fleam angle but avoid having an overfine unsupported tip, in hardwood. That also clarifies an explanation I got second-hand from my vendor on how and why the Japanese metate uses the third over-the-top facet.

Wiley

Re: saw sharpening device

#78

Re: Fleam and rake

Marv

>Wiley,

Again, for general purposes, I use a 15 degree rake angle on crosscut teeth. Other angles can be used to produce a more or less aggressive tooth.

Rake and fleam are independant. For example, on a rip tooth, we usually don't use any fleam angle at all, however sometimes it is used. It is believed that if a few degrees of fleam is used on a rip tooth it will cut better when sawing diagonal to the grain. IMO, a crosscut will do the job better.

Lowering the file handle or tilting the blade away from you as I think is what Warren is referring to is how we file sloped gullets and this added angle does produce a more pointy tooth just as when using an extreme fleam angle like 45 degrees. Both methods will produce a tooth that will dull faster, especially in hardwoods.

Marv