Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Hannes Caliper, Whoa......

Posts

Hannes Caliper, Whoa......

#1

Hannes Caliper, Whoa......

Dick Coers

I went to the Woodworking Shows near St. Louis yesterday. I hadn't been there for years, and had a little money burning a hole, so off I went. When I stopped by the Hannes Tool booth, I just couldn't resist. I do have some large bowl work on order, but doubt if I will come close to really needing the capacity of this thing. But it was just something about the scale..............20" overall height! I was tempted to take a picture like Steve Martin used to do with that arrow gag pulled over his head, but choose to just use a 4" caliper for comparison. Also picked up an offset pendant system, some silicon glueing sticks, some push sticks for the table saw, and a thing called a sanding file. Beautiful weather for the drive, fun spending the money, and had a nice visit with JoHannes. Great day!


Re: Hannes Caliper, Whoa......

#2

Keith Tompkins

Re: Hannes Caliper, Whoa......

Keith Tompkins

I have to say Johannes is one of my favorite turners; very high skill level and creativity. :)

Re: Hannes Caliper, Whoa......

#3

Aage Rendalen

His may be bigger than yours, but yours is better

Aage Rendalen

For finish-turning bowls, nothing beats your caliper. I use it religiously.

Re: Hannes Caliper, Whoa......

#4

Ditto that!

david

Keith's caliper is great and I use it a lot! Invaluable for bowls deeper than finger and thumb can reach.

Re: Hannes Caliper, Whoa......

#5

Keith Tompkins

Re: Thank you