Wedding ring
Roger in MO
I spent a very pleasant morning helping my grandson finish turning his wedding ring. He and his intended spent last night with me so we could get a good start.
He purchased a titanium bar, turned the o.d. of the bar on one end, drilled it slightly undersized, cut it off, rechecked the ring, bored the diameter. Then he turned a locust mandrel to a tight friction fit with the i.d. Then he rounded the top corners with a file. Sanding with 800,1500 and 2000 left a fine polished surface. Buffing with rouge did not improve the surface. He did buff the interior with an unidentified black abrasive compound from my treasure chest to eliminate the fine scratches from the boring bar.
The metal lathe is a WWII vintage South Bend 8" bench model. The wood lathe is a Jet 12-32. The titanium cut like butter but was difficult to form with a file. We are all pleased with the outcome and Grandpa enjoyed the company of the young folks, an infrequent event.
I will post pictures when I can find them in this xxxx new computer. 





