Re: 22" long 3/8" spindle
Bill Turpin in WNC mountains
At the 2006 AAW national symposium in Louisville, Joe Ruminski of Fairview, NC had a long dowel in the instant gallery that was 3/16" diameter by about 8 feet long. I believe he turned it on a PM3520. He used a piece of 1/2" EMT electrical conduit to support it before the headstock and after the tailstock. It passed thru the hollow quill of the headstock and tailstock. It had small coves about every 3/4". I know no other details. As a beginning turner it totally blew me away when I saw it at our club!

HI Bill, the piece must be small enough to pass through the headstock AND the chuck. Slide the piece through the chuck, and tighten, then turn. Loosen the chuck, slide the stock again, and turn. Support with tail stock, then use steady rest to stabilize....
We agree that the center is the weakest point, but if you turn it to finish diameter first, it's near impossible to do any delicate work at the tailstock end. In this finial for example, I turn the tip first, no support from the tailstock at all. Then, relying on the mass of the turning stock, I work towards the chuck, with the tip totally unsupported. Much more difficult to turn between centers, if not impossible for many turners. (been doing this a while 


