Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Anybody had any luck with Red Oak burl?

Posts

Anybody had any luck with Red Oak burl?

#1

Anybody had any luck with Red Oak burl?

Keith Newton

I've never had Oak burl that was very impressive, but I'm expecting to get a huge Red Oak tree, 4'9" diameter, which has two pretty large lumps that are giving me high hopes, just judging by the bark pattern. I'm pretty sure one will be somewhat hollow, but I'll take it anyway.

I'm hoping the trunk has a 1 ~ 2' hollow in it, which will make it easier to break down into billets for my Woodmizer. I can turn a log this size into almost all QS lumber.

Re: Anybody had any luck with Red Oak burl?

#2

Re: Anybody had any luck with Red Oak burl?

phillip Medghalchi

Keith, not the red oak, however, I turned a beautiful bowl out of the Live oak that grows around us a lot. I'll put a pic. for yo later on to see.

Re: Anybody had any luck with Red Oak burl?

#3

Chuck Jones - West TN

Not Much

Chuck Jones - West TN

I've had very little success with oak burls but here is one of the few that is still around.

Actually, I gave up on this one while I was roughing it out. I put it aside because I was afraid it was going to fly apart. Later a friend (a beginning woodturner :\ ) stole it from my shop without me knowing it, finished it, and left it on my porch while I was away.


Re: Anybody had any luck with Red Oak burl?

#4

Brad Vietje

Re: Anybody had any luck with Red Oak burl?

Brad Vietje

Keith,

Red Oak burl is usually pretty nice to work with. If it looks like the "lumps" are healed over "scabs" where a branch broke off, and not actual burls, you will still get nicely figured wood, but there will be a big, nasty, dead, rotted part in the middle.

I usually use these "healing growths" by making a few natural edge bowls around the sides of the "lumps" to avoid the dead pocket in the center. For really big ones, the options are almost endless. I made a few nice 8" hollow forms out of a large Maple "scab" about 10 years ago. I only mention this because I was seduced into trying for a single larger bowl or other turning, only to have it ruined by a big dead and rotten stick in the middle.

Have fun & safe spinning,

Brad Vietje

Newbury, VT

Re: Anybody had any luck with Red Oak burl?

#5

Back In The Day

Mark Mandell - Gone Round In New Jersey

When all I had to turn was oak, I took on this crotch.



As it was twice turned I needed to soak the inclusions with epoxy and keep the water bottle handy.

I got to really dislike figured oak :D

Re: Anybody had any luck with Red Oak burl?

#6

Re: Anybody had any luck with Red Oak burl?

ron bauer

Keith, I have had good luck with Red Oak burl. It produced a deeply rich brown, highly figured natural edge bowl...one of my all time favorites. I also have one in my pile that is, seriously, 36" diameter where it meets the trunk. It seems to be solid. I am going to take it to a friend with a saw mill like yours and have it cut off in several pieces. I might even take one slab and, horror of horrors, make a table.