Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Cherry bowl finish

Posts

Cherry bowl finish

#1

Cherry bowl finish

Jerry Lear

I finished a cherry bowl, sanded it to 320 & thought it would look good finished with the Beal Buffing System. After going through three stages of buffing on the outside, the finish did not look very good. The bowl needs to have a bit more luster & I am wondering how I can achieve it after having already waxed the bowl. Can you put wipe on poly over the wax? If not, what suggestions would you have to achieve a more lustrous finish.

Thanks in advance for your help,

Jerry

Re: Cherry bowl finish

#2

Re: Cherry bowl finish

John Veerkamp

You'll need to remove the wax. A couple of good wipe downs with mineral spirits should do the trick. I'd then seal the wood with a sanding sealer before applying your poly finish.

Re: Cherry bowl finish

#3

Re: Cherry bowl finish

Dick Coers

Nothing sticks to wax. What was the original finish? How long did you wait before buffing? I think naptha works better than mineral spirits.

Re: Cherry bowl finish

#4

Re: Cherry bowl finish *LINK*

Mike Brazeau

My favorite finish for cherry flat or round is to apply heated Boiled Linseed Oil. I learned this technique from Thomas Moser, in his book on making Shaker Furniture. If you take the shop tour at his website http://www.thosmoser.com/page.php?page_id=56 it is detailed in the finishing portion of the tour. Shop tour is in Flash so will not work on iPad as I found out before I moved this post to my laptop! He recommends heating the oil to 170F. I also have a very old reference from Fine Woodworking about applying heated oils. I would wipe a couple of times with a strong solvent as Dick recommends and perhaps re-sand by hand with your last two grits. I used to use a double boiler technique with oil in a coffee can but now just heat a small amount in a can with a heat gun and brush oil a generous application. The hot oil should blend with any residual wax. Have a look a the Cherry Crotch Bowl at link below in Turned Bowls album. Also have a reference in the Berceau Album. I find the hot oil enhances the penetration and speeds up the cure and BLO really enhances the darkening process. That bowl darkened in a few months and is an incredible color now and quite shiny. Satiny shine with an oil finish is related to the amount of effort you put into sanding.


The Joy of Wod

Re: Cherry bowl finish

#5

Re: Cherry bowl finish

don stephan

Is"more lustrous" intended to mean a higher sheen? And will the bowl ever be exposed to water, such as handwashing after used for snacks, cereal, salad, . . .?

Re: Cherry bowl finish

#6

Re: Cherry bowl finish

david

This has worked for me in the past, but use at your own risk. Rub thoroughly with 0000 steel wool and apply Waterlox Glossy Finish until it does not absorb any more. Shouldn't take more than 2-3 coats and it dries fast. There should be some shiny patches. Rub all over with steel wool again before going through the Beal buffing.