Wellllllllllllllllllllllllllllllllllllll, I'll be
Alan Sweet
However, I know that when it comes to sanding and finishing, I like a reverse.
1. Sanding. When turning, the angle of the cut versus the grain changes as the wood turns. From long grain to cross grain. As a result, the ends of the grain differ greatly in the circumference of a spindle or bowl exterior. Sanding is no more than a finer cut over the grain. The tighter, and smaller, the grain the less you will notice any difference, but the ends of the grain will be different. Sanding will attack the grain ends more aggressively on one side of the grain cut and have a tendency to fold over one side the grain tube. By sanding alternatively, using reverse, one can address some of this difference. The surface can be sanded more consistently.
Experiment. Take a piece of 4/4 poplar or oak and turn a platter. Sand it one direction to any level. It can feel smooth. Walk away for say 10 minutes. Feel the surface again, one direction will fell much better than the other. The feel with the sanding direction will feel smoother than the feel against the sanding direction. I think reverse helps to address this.
2. Finishing. I finish with my lathe on and feel that I can get a smoother finish by reversing the lathe between coats of finish. Sometimes I sand between coats and reverse as I sand. Again, I am of the opinion that I can get a better finish because of reverse.
These are all just my opinion and only based on my limited experience.