Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Glue Block question

Posts

Re: Glue Block question

#26

Re: Glue Block question

Wally Dickerman

Ken, you should be able to remove the piece with the glue block from the lathe and remount it later. I rough turn most of my pieces and remount and finish them later. Never a problem.

There are several ways to mount the piece when using a glue block. After attaching the glue block you can cut a tenon to use a chuck, or you can drill a hole to use a screwchuck, or you can mount a faceplate. If you use a faceplate, make a permanent mark on the faceplate edge. Before you remove the faceplate make a similar mark on the glue block so it goes back on exactly where it was before. Done that many times in the old days.

I remove the piece from the glue block using a parting tool at the glue line. On a small piece I cut down until the glue joint is about the size of a dime. Give the piece a bump and it comes off. Usually the glue block breaks instead of the glue joint.

Re: Glue Block question

#27

Re: Glue Block question

John Lucas

I use glue blocks on a large number of projects. The only time I've had CA not harden is when it gets old. It does take a long time if you don't use accelerator and you font have flat surfaces. Flat surfaces glue much better than concave. Accelerator makes the joint brittle. I use this to my advantage. If you hit the chisel hard and fast the glue line breaks leaving bothe the piece and the glue block clean and re usable. This can be a problem if you get a catch or cut too aggressively. The piece will call off. Some CA glues are more brittle than others when you use accelerator. Bad CA glue gets really brittle u

Re: Glue Block question

#28

Holt melt glues ....

Geoff Whaling

Not all holt melt glue sticks are suitable for woodturning applications, many are best described as craft glue. I prefer the Bostick range & I know Terry Scott (NZ) uses hot melt glue by the trailer load.

I prefer to use Titebond II or AVSyntec AVXL Plus glues myself & haven't had any glue blocks seperate after a 12 hour set. The AVXL Plus is a "fast grab" glue, so you can cheat a little if you are so inclined. For fast jobs holt melt is the go & I also have not had a problem but I am very wary of CA glues for the reasons already mentioned. CA is a little to unpredictable for me and has the added hazard of spinning out uncured glue.

With removing & then repositioning the glue block on a face plate - why bother? Face plates are very cheap compared to a chuck by a factor of at least 4 to 1. Vermec & other manufacturers have a great range of face plates from 75mm (3") to 150mm (6") + with interchangeable threaded inserts so there is no need to remove the glue block from the faceplate.