Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

anyone know about garage doors?

Posts

anyone know about garage doors?

#1

Steven Antonucci

anyone know about garage doors?

Steven Antonucci

A couple of months ago, one of the springs in my garage door let loose. I knew that there was a spare from when I purchase the house 15 years ago, so I dug it out and put it in. Started having issues with the door not closing right, and it was because the lower left pin on the wheel thingy won't stay in the thingy holder. it is like the door is crooked?

Fast forward to yesterday when I replaced both springs with new ones because I was told you have to replace them in pairs. I weighed the door to make sure I had the right ones, and the problem is actually worse now...

Any thoughts?

Steve

Re: anyone know about garage doors?

#2

Since your door has ...........

JamieDonaldson

...2 springs, they have to be equally tensioned. Any individual spring variation will "unbalance" the alignment, and is also how the movement can be adjusted. Be very cautious with those tensioned springs, as they have some serious stored energy when properly adjusted!

Re: anyone know about garage doors?

#3

Lyle Jamieson

Re: anyone know about garage doors?

Lyle Jamieson

The spring is hooked to a cable, the cable has a thingy that connects to the support . The support has holes in it for adjusting the spring tension. The spring cable thingy can be adjusted up and down on the cable to further adjust the cable. With the door up and both springs loose make sure they are in the same position on both sides. Or if you can tell which side is the loosest one tighten the cable til they balance. It only has to be close...not perfect balance. Just so one spring is not pulling the door crooked.

Re: anyone know about garage doors?

#4

Those things scare me..

steve worcester

so I use a pro to do it. No one dies that way

Re: anyone know about garage doors?

#5

Re: anyone know about garage doors?

phillip medghalchi

Steven, spend $150.00 and have the guy fix it for you or spend two weeks and fool around with it and then spend the money. BTW, if you it take on make sure that your life insurance is in a safe palce because there had been some serious injuries and death reported with this task. :D

Re: anyone know about garage doors?

#6

Re: anyone know about garage doors?

John Lucas

I didn't find it that big of a job to adjust mine when I move here. It was off but it only took about 30 minutes of playing with the adjustments on both sides. Do the adjustments with the door open so the spring tension is reduces. It didn't seem all the dangerous to me.

Re: anyone know about garage doors?

#7

Re: anyone know about garage doors?

bill Crommett

It would be best if the object was clearly identified. There are at least two different types of spring helpers.

The dangerous ones are the long 4 inch diameter springs that are on the rod at the top of the door. These are the dangerous ones. Then there are the smaller ones that go on the cables. I have messed up both systems, but the worst was when I wound the big horizontal spring backwards once. Scary !

Re: anyone know about garage doors?

#8

Re: anyone know about garage doors?

Galen Vetterick

Picture this.

Some guy standing on a ladder trying to adjust one side tension spring through cable system. He's watching door slowly go over center and he's only fearing the wood and glass door is going to shatter when it hits bottom (all in slow motion).

Guy on the ladder now suddenly has his fingers between cable and pulley now under full tension. Glad he had good lungs cause somebody heard him and raised the door to get to the guy on the ladder.

Me? :(

He was young and stupid them. Now old and urr, still stupid at times.

Re: anyone know about garage doors?

#9

Roger in MO

Re: anyone know about garage doors?

Roger in MO

A spring broke for me one time as the door was going down. Scary! Since then I thread a small cable through the spring and attach both ends to something solid.

Like John said, make adjustments with the door in the raised position.

Re: anyone know about garage doors?

#10

Dick Hines

Re: anyone know about garage doors?

Dick Hines

All this talk about the thingy but you checked the whozzett. :D

Just be careful what every you do. I had one brake last fall. Went to a door company, I will not say which one, and they would not sell me a spring. They said if I got hurt I could sue them. So I went to the local Ace and bought one.

The doors that have the springs on each side are hot hard to repair. The ones with the big spring around a axle you should leave to the pros.

Re: anyone know about garage doors?

#11

Lyle Jamieson

Re: anyone know about garage doors?

Lyle Jamieson

The dangerous part is if something is hooked up wrong or something breaks while the door is down and springs are fully extended. Don't be in the same room when you put the door down the first time. I had the bolts come out of a double 2x6 support brace once. It was scary...very violent.

Re: anyone know about garage doors?

#12

Re: anyone know about garage doors?

Don Evans

John:

You obviously have the little ones because you cannot adjust the big one's that are so dangerous with the door OPEN.

The one's that go on the header above the door are about 30" long and 3" in diameter and they are slide onto a steel rod that runs the width of the door.

You have to use 2 steel rods 1/2" diameter to tension them or detention them and it is a serious operation, one slip (not getting one of the rod fully in the hole) and Kathy bar the door! No way would I take on that type, I let the door guy do it.

Don

Re: anyone know about garage doors?

#13

Re: anyone know about garage doors?

Don Wilcut

Let the pros handle it.