When this topic came up last time, and I mentioned the blades not being spot on, Bill Grumbine mentioned that he never noticed it, and had learned to work with them as they come. A blade that is not a perfect arc of a circle will not make a perfect arc of a cut, and you have to compensate. If you have one of the plastic circle template things, some time try laying it over the top of some of your blades to see how closely the curves match.
robo hippy
Re: Continuing my love/hate (mostly hate) relationship
Somewhere It got lost in the translation and seemed like everyone is referring to using the tailstock on the coring tool. I don't see how that's possible so I'm guessing it's to hold the bowl. Am I wrong.
I'm very new at coring. I have enough free wood that isn't that rare so I just turn bowls and toss the waste. I have cored about 15 or so on wood that I had to save and for a little practice. I find the tool very hard to use but have been reading these closely and have bookmarked the video and will watch it some day soon.
Re: Continuing my love/hate (mostly hate) relationship
Yes, using the tail stock when coring with the Kelton helps a lot, and the bowl cannot take flight. As the handle gets on the way I use no handle at all.
I prep the blank by drilling for the screw chuck, mount on that, make a tenon and shape the outside, Mount on the chuck using the tenon and bring the tail stock and make the biggest core, remove the biggest rough bowl and remount using the screw chuck, repeat as many times as you can, it is quite self explanatory.
My last sentence is incomplete it should read "When using the Oneway jig I core from smaller to bigger" as the base for the support of the knife prevents from using it the tail stock, I take weight away by coring the smallest first and so on and you mount only once. I start the same way, use the screw chuck to make tenon and shape the outside, then mount o the chuck and core away. I use the Oneway coring jig when I have very big blanks. The Oneway is easier to use, but you can only make one shape, the Kelton is more versatile.
Re: Continuing my love/hate (mostly hate) relationship
They have been working on it for over a year. I think they will have to totally redo their platform. As far as I am concerned, it will take a lot of beefing up to take the cutting loads of a bigger blade. Just attaching to the tailstock isn't enough to handle a blade sticking out that far. It chatters a bit as is.
robo hippy
Re: Continuing my love/hate (mostly hate) relationship
I had to go back and watch the video again and to see what you were referring to about the new comment. The question someone asked was edited and I don't recall what it was. I am sure that the rest wasn't edited since I was letting folks know of videos that were available. After viewing the video again that section did not flow/edit well so it looks as though I am putting a knife in your back. I apologize since that was not my intent.
It has been awhile since I watched the video and did the other day. There were a few other things edited such as the importance of wearing a face shield. You can hear me later say "You see why it is important to wear your face shield" (something like that) since when starting the cut the chips fly back into your face. I most the time deflect these with my hand but I did not want to block the video shot of starting the cut.
I hope you accept my apologies, I take full responsibility for not asking Hoyle to edit that section better. It was missed.
Dale A. Bonertz
Re: Continuing my love/hate (mostly hate) relationship
You are making me feel bad now. I was curious, not upset. A link to the video was put up on Woodturner's Resource in their video section, and I commented that it was pretty good. No apology needed. I do like Mike's second version much better than his first one. He does so many things on instinct that many of us don't have. I do like his approach though, and for sure his mastery of the tool. I just do things differently.