Leaf Litter
Terry Scott
Leaf litter
The inspiration came from weeding under the large Puiri that is the focal point as you enter into our property. As the soil is mostly heavy clays I thought the Burl would tie in with the theme
300mm Dia Red Mallee Burl
Turned with my support ring process, this was a flat Mallee burl cap
I turned thin enough but thick enough on the rim to carve in the leaves which are life size. Gauging the finished thickness so I didn’t go through was achieved with my 2 finger gauge, thumb and middle finger
All done with the Nsk (yes I give it heaps)A dremel would have struggled as this was so hard the extra rpm the Nsk had left clean un-burnt cuts.
Four different sized Inverted cones were used. Nine bits in total went into my I cannot throw anything away bit jar
Indian inks, gold leaf and finished with lacquer.
I may go over the leaves with a brass wire brush in the dremel to take away some of the sheen.
Sits on three feet blended into the curve of the bowl.
Yes it’s been a while between Pieces
Comments welcome





