Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Delta extension

Posts

Delta extension

#1

Delta extension

Richard Monroe

I have a Delta 46-460 Lathe with a 25" extension. This gives me about 43" inches of space. I make walking sticks that are 48-60" in length. I have had to join these sticks with either brass or wood joins. I feel with the brass joins this leaves a weak spot in the stick. With the wood joins, it seems to take too long to make any kind of profit from them at Craft Shows. Would it be foolish to purchase one more extension for the lathe? The second extension would give me about 67" and all the room I would need, even for drilling. Other than alignment issues and whip, I have the OneWay spindle steady, are there any issues with having too long a lathe? Thanks in advance for your responses. Richard

Re: Delta extension

#2

Re: Delta extension

Harry in Beautiful Downtown Kulpsville

At the Woodcraft store where our club meets, one of our members and a Rikon rep added three or four extensions to one of their mini lathes and turned a huge baseball bat. I didn't hear of any problems.

I made a bed extension for my Nova DVR that fastened to the bed the same way the banjo or tailstock does. I used a 2x4 to rest on the bed, more pieces of 2x4 to make a vertical piece and a sharpened piece of "all-thread" as a dead center. I mae a couple canes for the Eagle cane project and it worked reasonably well. Almost zero cost!

Re: Delta extension

#3

Can use up to 3 extension beds,

John Kaner

giving you 42 inches, 67 1/2 inches or a huge 93 inches!

When the Delta Rep demoed this lathe several years ago, he had it set with several beds. He said this was a lathe that many wood turners comments were used to develop it. They used the same process on the then new unisaw.