Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Making dowels - questions

Posts

Re: Making dowels - questions

#26

Mike Stafford

Re: Oh good Lord......

Mike Stafford

We can only hope that out of frame there is a clamp holding it to his backing board, Dick.

Re: Making dowels - questions

#27

Steven Antonucci

I thought that too

Steven Antonucci

Following the idea without the bad parts... a simple vise or clamp to hold it down.

S

Re: Making dowels - questions

#28

Re: I thought that too

John Lucas

I'll admit though I've done it too. Been wacked once or twice so you'd think I would learn. Thicker steel isn't as bad a problem as sheet metal. Drilling sheet metal is just downright dangerous.

Re: Making dowels - questions

#29

Your a good man Lan


Re: Making dowels - questions

#30

Re: Making dowels - questions

Paul Leuba

I've had good luck using a steady rest in turning 3/4" oak blanks 24" long for Windsor chair spindles between centers where the diameter off the thinest part off the lath is 1/2". I then go to a shave horse and spoke shave to finish the thin part of the spindle to about 3/8" to 7/16". I move the steady rest a couple times from near the tail stock (thin part of the spindle) to near the head stock as I work in that direction. My preferred cutting tool for this is a skew.

Paul in Hunt Valley, MD

Re: Making dowels - questions

#31

Leo Cuellar

Re: I thought that too

Leo Cuellar

With a piece of steel that long, I just lay the opposite end against the drill press post and let the rotation work for me instead of against me. Never injured myself doing it that way. Shorter stock always gets clamped though.

Nice simple cutter though, might have to add a few of those. Thanks for the link, Steve!

Re: Making dowels - questions

#32

Re: talking about noodles Mike....

Barry

Uh..........it's not good to believe everything you see on TV. You don't always see everything that went into the process............like how many duds went into the dumpster before they got one good one for the camera!

Re: Making dowels - questions

#33

Re: Use the router if you have one.

Barry

I think Beall has a commercially-made jigs for dowel-making.

Re: Making dowels - questions

#34

Re: Brute Force:  Turn 'em!

Barry

Doc, I admire your confidence. You are undoubtedly a much better turner than me. I've been turning for several years and no way would I attempt to turn 40 3/4" X 24" dowels. Spindle whip is going to be a terrible problem. So is breakage. There are much more efficient ways to make dowels, some of which have been outlined in other posts. By the time our friend finishes turning 40 of these, he will be a much better dowel-turner. I'm a little unsure of the value of these new skills, unless our friend is thinking of seeking employment in a broom handle factory. Are you aware that dowels can be purchased in a variety of sizes at a big-box store? Maybe not in heart pine, but several woods varieties are available.

Re: Making dowels - questions

#35

Many thanks for great ideas

Henry (Raleigh NC)

I'll post my chosen method once I try some of these great ideas.

Henry

Re: Making dowels - questions

#36

Mike Stafford

Ain't it great.....

Mike Stafford

to know how many ways you can skin a cat or make a dowel? :D