Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

6 inch X 49 inch sander

Posts

6 inch X 49 inch sander

#1

6 inch X 49 inch sander

bill Crommett

I am not as sharp as I once was, and that causes many problems. I have a 6 inch sander that I used to use to flatten segment rings until I got a Performax.

After a couple of years of neglect I decided to put a new belt on it, but I can,t remember which way the belt migrates. Is it to the high side of the rollers or to the low side ? I wore out both thumbs before giving up, and now I ask for help.

Re: 6 inch X 49 inch sander

#2

Chuck Jones - West TN

Re: 6 inch X 48 inch sander

Chuck Jones - West TN

To the low side if I understand your question correctly. I guess I'd refer to it as the side that is not as tight. If it's like mine it takes a very, very little movement of the wrench (assuming that's how yours tightens) to start that sucker in the other direction. I just have to keep finessing it a tiny bit at a time until I get it. Then I lock the adjustment bolts down... and then start all over again. :)

I'm assuming the 6 x49 is a typo and it's really 6x 48. If not then I need to hush because it's not like mine.

Re: 6 inch X 49 inch sander

#3

Re: Stated another way....

Steve Criscenzo

Add tension to the side the belt it is migrating to. It usualy takes very little adjustment o make the belt move. If the belt gets too tight, take some tension off on the side opposite the direction the belt wants to move. Be sure to get the belt reasonably tight before starting adjusting or you are wating your time.

My unit has holes in the adjustment knobs. I use a piece of round bar in these holes to turn the knob. it save my thumbs and allows me to get some tension on the belt.

Re: 6 inch X 49 inch sander

#4

Re: Stated another way....

bill Crommett

Thank you Steve and Chuck. Yes the 49 was overkill by numb fingers.

I thought that I had loosened the tension in exact increments when I took the old belt off so I would not have this problem. It looks like "exact" isn't what it used to be.