We're missing a good market *LINK*
http://www.foxnews.com/leisure/2012/03/25/eight-luxe-wastebaskets/?intcmp=features
We're missing a good market *LINK*
Posts
Re: We're missing a good market *LINK*
#2$2400?! where did we go wrong?
Re: We're missing a good market *LINK*
#3
Re: We're missing a good market
Mike Stafford
You know, I have made a few wooden wastebaskets in my time. One is sitting in the den where I am right now.
I mentioned to my wife that there was a wooden wastebasket for sale at $2400. She said she would be willing to part with the one I built for a lot less..... 
I guess she doesn't like wooden wastebaskets.....
Re: We're missing a good market *LINK*
#4Brad Sells waste basket
John Lucas
As some of you know I photograph for Brad Sells. He does very high end sculptural bowls. When he was first starting out his bowls sold in the $500 to $1000 range at Craft Shows. One guy came up and looked at a tall one and said "can I use that as a waste basket in my Office" Brad said of course and sold it. I guess the guy has more cash to spare than I do.
Re: We're missing a good market *LINK*
#5
Re: We're missing a good market
Leo Cuellar
Nice link, John. Hadn't quite gotten to the waste can idea, but paper management was on my mind.
I was going to buy a couple of matched bead & cove bits at Grizzly to do some staved work. I wanted to see if a rounded joint would offer more leniency at glue up.
Re: We're missing a good market *LINK*
#6Re: We're missing a good market
john lucas
Leo Have you looked at the matching canoe bits that make a round groove on one side and bead in the other. Don't know how well that would hold up but certainly let you attach them at any angle. I've looked but not purchased because I have another project that could use them. It's not turned so I'm not worried about the joint flying apart.
Re: We're missing a good market *LINK*
#7Leo, check this out...
John Kaner
http://www.woodmagazine.com/woodworking-plans/routing/birds-mouth-bits/
These are birdsmouth bits. The article shows some ideas and how they work. They are used for stave construction. Only one side of the board is routed...
Hope this helps.
Re: We're missing a good market *LINK*
#8
Re: We're missing a good market
Leo Cuellar
I think those would do pretty well, John, depending on a solid glue joint. Right now, I've got several hundred bf of pretty & inexpensive 3/4" Maple to play with so I'll be starting off with larger bits to begin with. Some stretch wrap or tape might be a good insurance policy until I feel my way through this. The only problem is I'll have to keep my table saw clean for a while 
Re: We're missing a good market *LINK*
#9Re: We're missing a good market
Jorge
I have the canoe bits and they work very well, but only in 5/16" stock.
You can try bead and cove bits of any size and see how that works.
Re: We're missing a good market *LINK*
#10Way to go, John__
david
Appreciate the link. Got the old brain working thinking of the possibilities.



