How-to, LONG
Steve Kubien
Thanks Gary. I've gotten a couple of emails about the beads so here you go...
No pen beader or other beading tool was used. I used a 3/8" detail spindle gouge. I saw a clip of Richard Raffan doing this (somewhere) and he is what I am doing because of that clip...
Start with the handle low and the flute rolled over a 9 o'clock. The flute orientation will not change. Slowly but steadily, raise the handle which in turn, puts the tip into the wood. Again lower the handle and let the tip skate up the left side of the valley you just cut. As the tip gets to the top, don't lose contact but move the tip in a circular fashion until it is lined up with where you want the next valley to be. Raise the handle as the tip continues to move in that circular motion. Thoughout this, keep the flute pointing at 9 o'clock. You are NOT rolling the tool like you would normally do. Keep repeating this until you have a band of beads the width you want.
In one of the emails I received, the author said how he had a problem doing small beads in bowls because of the fuzzies left at the bottom of the cut. My, albeit limited, experience tells me this isn't an issue and I think this is because the tool is constantly cutting. The tip never leaves the wood until you have a band of beads as wide as you want. If you disengage the tool from the cut and decide to add more beads after, you have to get the tip back into the bottom of the left-most valley EXACTLY where you stopped before. If you don't, you get the fuzzies and a raised hair of wood around the entire bowl. I think that is a PITA, especially when you've got a bowl spinning at a few hundred RPM's. I don't like that much excitement.
So far, my experiences with dry, locally reclaimed wood have not been encouraging but in this wet honey locust, I love the results and they were easy to get.
Hope this helps!