Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

what causes this and i hate glue...

Posts

Re: what causes this and i hate glue...

#26

Steven Antonucci

Two thing I would almost guarantee you did?

steven antonucci

1.) cut from the natural edge to the foot. It's the wrong direction, and will produce this effect without fail.

2.) probably didn't have a bevel rubbing? If you scraped this, you need to work in lighter passes...

Didn't read the whole thread... but I'd bet that I am probably right?

Steve

Re: what causes this and i hate glue...

#27

Re: Getting Back To Basics (Long, As Usual!)

darrin hill

"Your photos show rather severe tear-out, which is typical for beginners using either dull tools, or a poor cutting technique (probably scraping, not really cutting). If you can see light between the bowl and the bevel of the gouge, you're scraping, not cutting."

so what if u can't see light between the bowl and the bevel and your gouge is sharp enough to cut paper?

and why am i using a glue block? Because everyone in my local group said to..

funny thing.. most wood turners are older retired people.. I just listen to my elders. I'm a firm believer that 99% of the people on the internet, if told to do something by another person, will just do what they're told.. The other 1% are the people who will stop and investigate, search for data, experiment, make their own tools, lathes, etc, make sandpaper from toilet paper and sand, and sit down and design a finial. Although it seems that 1% is the majority of people here on WC and I'm in the minority.

If someone tells me to use a glue block, i will use a block. I was using an expanding recess and dovetail on my chuck, but they said to use a tenon because of the points of contact in compression holds tighter than expansion..

and i don't argue with my elders who are engineers or science people. Im a liberal arts major who couldn't design a nail, but i can tell you how well it goes with chartreuse.. I think I'm going to use that as my signature.. Lol

to make things easier to understand, i have a local group. Two members of which are named Andrew Chen and Jerry Bennett. So u see who i think i should be judging my stuff against...

Re: what causes this and i hate glue...

#28

Brad Vietje

Take A Class, Then.


Re: what causes this and i hate glue...

#29

k.. maybe i listened a bit

darrin hill

ok.. so i slowed down.. the lathe... went down to 100 rpms. paid really close attention to the bowl gouge edge...

bowl came out smooth as a baby;s backend.. so then i took that square nosed scraper i had in the earlier photos.. tried to smooth out a few ridges..

the fuzz was all back.

so its the scraper..

i bought it from a guy on woodturning online with a set.. i have not used it much, but I'm not sure it's sharpened correctly.. do you smooth out the top flat side ? cause it has marks on it like the top was smoothed with a grinding wheel...and the bevel is angled, but dunno how to sharpen the scraper correctly.... i have a wolverine platform sharpener, but was wondering if i need to use a stone and do it by hand..

so i did slow down to check...

Re: what causes this and i hate glue...

#30

Sharpening a scraper *LINK*

Doc Green

Darrin,

There is an article on my website that explains how to sharpen a scraper (actually, three different ways).

There's more to sharpening a scraper than simply running it across a grinding wheel . . . the burr determines how the scraper will behave in a cut. Unless you pay attention to the burr, the scraper is likely to be rather unpredictable and frustrating.


Doc's Website