Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

bracelet

Posts

bracelet

#1

bracelet

gary clarke

I am looking for different ways to reverse turn a bracelet. Thanks

Re: bracelet

#2

Re: bracelet

Emmett Manley, Lakeland, TN

Don't reverse turn, make the parting cut from one side only. Do this by using a screw chuck or glue chuck that allows room for the parting tool to go all the way through the wood without hitting anything on the headstock.

Remember to keep your parting tool perfectly in line with the lathe rails (ways) to make the critical right angle single cut.

Re: bracelet

#3

Steven Antonucci

What I've done

steven antonucci

Turn between centers with a tenon on either side.

Grip side one. Part about 1" deep

Grip Side two. Complete Parting.

You should have a tube. Insert tube around chuck jaws from inside and marginally tighten. You can wrap the outside with painters tape to secure it to the chuck if you are uncertain.

Cut inside of bracelet cleanly. Sand to finish.

Reverse it to the finished interior, adding tape to the outside of the jaws to keep the inside clear. Finish cutting and sanding side 2.

done.

Steve

Re: bracelet

#4

Re: What I've done

Gary clarke

Thanks

Re: bracelet

#5

Re: bracelet *LINK*

Kevin Stanbary in McHenry, IL

Bob Hamilton does napkin rings like this, could be easily adapted to bracelets...


http://youtu.be/rfrldsntWbA

Re: bracelet

#6

Re: bracelet

gary clarke

That would well for the segmented braclets that I will be doing. Thanks

Re: bracelet

#7

Ken Vaughan

Re: bracelet

Ken Vaughan

Pictures from an older article by Nick Arull (2008)

I think he calls them Bangles

http://www.woodworkersinstitute.com/page.asp?p=594