Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

LEDs and thin turning

Posts

LEDs and thin turning

#1

LEDs and thin turning

Hal Taylor

Curious, has anyone thought about making, and even better, made a light source for thin walled turning out of a LED device? Usually what has been used is an automotive, 12V light bulb. An LED may be a better solution.

Re: LEDs and thin turning

#2

Re: LEDs and thin turning

steve worcester

I haven't made one, but it would be lower heat, possibly brighter, and the narrow beam may actually work better for this application. Way more rugged

Steve Worcester

WWW.TURNINGWOOD.COM

Re: LEDs and thin turning

#3

Re: LEDs and thin turning *LINK*

Craig Daymon

I'm guessing what you are talking about is a light that sits on the turning tool near the tip at the end of some sort of cable? I think it has been done, but I don't know if it has been done commercially. I think part of the issue, at least this was true a few years ago, is that LEDs don't produce nearly the light that conventional bulbs do, at least without bundling several together (lumens). A better approach, if this is still the case w.r.t. the the lumens produced, might be to use fiber optic cable with the light transmitted down the cable from a more powerful source. The cost might be higher though.

Woodcraft currently has a 7 LED, 2 power source, gooseneck light with a magnetic base on sale for $24.99. (It takes 3 AAA or 110 AC. Personally, I like not having to use batteries.) I'll probably pick one up soon as I need more light at the lathe. They don't give the size of the head, but it looks a bit big for an Ellsworth opening. It produces 180 lumens.

-Craig


Woodcraft 7 LED gooseneck light

Re: LEDs and thin turning

#4

Re: LEDs and thin turning

Donna Banfield

What you are describing is a fiber optic light, and J. Paul Fennell uses one when turning his hollow forms. He also sells this ready to use. Here's a photo of him demonstrating the use in turning a hollow form in my shop earlier this fall.

Re: LEDs and thin turning

#5

Re: LEDs and thin turning

Hal Taylor

I had made a similar version of Herm de Vries fiber optic device (see his website) but I was not able to get a bright enough light to come out the fiber end. (I'm still trying.) I searched the WC archives on 'fiber optic' and found some good threads one of which was one using an LED which I may be able to do.

Thanks Donna for your info on J Paul Fennel's light source. It looks really good but has a hefty price, which I'm sure is a good price for the unit.

Re: LEDs and thin turning

#6

Ian Outshoorn

Re: LEDs and thin turning

Ian Outshoorn

I use a 50w GUD10 fitting LED that is used to replace halogens when I'm turning hats. It's fitted to a steel tube and runs through the head stock. Runs 12V and and runs cold. This means that I don't overheat the inside of the hat. The light is quite white and works for me when I need a closeup spot light that won't set fire to what little hair I have. Mind you, I showed it to Gordon Pembridge when he was doing his Pyro work and he didn't like the colour it cast. You mileage may vary. Cheers Ian