OT: Portable generators video
Alan Zenreich
In a recent thread about electric chainsaw sharpeners, a member mentioned that he uses files and sharpens by hand. He also said that the file method was particularly effective when using the chainsaw during a power outage caused by a storm. An electric sharpener would have made a nice paperweight without having some electric power nearby.
Providing power when during a blackout has recently been on the minds of homeowners. Generator sales have been brisk!
Here's a little video I made this weekend showing the way I've set up a pair of portable generators to supply power to my home.
http://www.youtube.com/watch?v=Y2B4Vvz9Xqw
Unlike many rural areas, my area of northern NJ rarely loses power.
That is, until recently.
With hurricane Irene, followed shortly by a freak October snowstorm, much of our area lost power twice in six weeks. Many were without power for several days each time.
For years, I considered getting some sort of generator. It was hurricane Irene advancing towards NJ that caused me to act.
In the few days before the storm, I learned more about portable generators than anyone should be able to ingest. I also found out that virtually everyone was sold out of generators. People were scrambling to get any contractor grade generator they could find... at any cost.
A few hours before the hurricane hit my area, I managed to find a gently used Honda Eu2000i 2000 watt inverter generator on craigslist. This model is the darling of the RV and camping crowd because it's very quiet, only weighs 47 lbs, sips fuel, and puts out very clean power (unlike most contractor generators).
I figured that having the generator would be like having a scarecrow. I would buy a generator and the power will never go out for the rest of my life.
Strangely, it didn't work that way. The hurricane hit, the power went out, and I hooked up the generator via extension cords to various items in the house.
The main concern was powering our sump pump. There is an underground brook about a block from our house, and with the rising water table, we watched the sump fill over and over again. The thought of having a pump with no power was a driving force for acquiring some portable power.
We sent one extension cord into the living room, and we hooked up those lovely LED gooseneck lights from Ikea, and connected the TV equipment so we could watch DVDs (power to the cable provider was out, so no incoming cable signal).
We kept our portable electronics charged (radios, flashlights, cell phones), and having internet service available via an iPhone and an iPad kept us connected to the net.
We used one cord to alternately plug into our refrigerator and our freezer... a couple of hours for each then switched. I used a couple of Kill-A-Watt meters at the end of the cords to get an idea of how much wattage was being supplied to each circuit.
The Eu2000i has a 1 gallon internal fuel tank, and gets from 4 to 9 hours runtime off of a tank. This is great... except if you want to run unattended throughout the night (which is particularly useful for the sump pump). So taking a cue from the camping crowd, I went to a marine store and got an auxiliary fuel tank, hoses, quick connects, and then modified the generator's fuel cap to accept the incoming fuel.
This worked great, and kept us going for the couple of days that the power was out. I even played around with the generator powering a Stihl electric chain saw, and that was a cool combination for cutting up downed limbs. Yes I have a gas Stihl saw too, but I just had to see if the generator would do the job... and it would have powered my chain sharpener too (see the connection to the original post?)
A few weeks later, that freaky October snowstorm hit. Because all the leaves were still on the trees, the wet heavy snow caused lots of tree and power line damage. Power was out all over the place... except on our block.
We had some limbs hanging precariously on the power lines, but we never lost utility power.
Friends of ours were not so lucky. They live a few towns up, and were keeping warm by staying in their car. We offered to have them come here, but the husband was coming down with flu-like symptoms, and didn't want to get everyone sick. There were no hotel rooms available in the area, and they have a large dog to care for.
So I decided to take my portable generator setup to their house. A few minutes later the generator, auxiliary fuel tank and extension cords were loaded in the car. It took only a few minutes to hook up the generator, and run some extension cords into their house. This powered a 1500 watt electric heater (it was 38 degrees outside) and the aforementioned LED lights... and they were able to stay in their home for the 5 days that the electricity was out.
It was a pleasure to see the generator put to good use, it was a neighborly thing to do. My offer to let them use the generator had one condition though: if MY power went out, I was going to take the generator back to my home.
Fortuntately, this didn't happen, but it got me thinking about future generator use cases.
My main concern was what would happen if we lost power in the winter when really cold outside. It would be great to let our furnace heat the house. Fortunately, we have gas powered steam heat, and the only electrcity necessary is to run the thermostat and open the electric flue damper. But this is not easily configured for an extension cord input... so I looked for a better solution to allow the generator to supply power to the house wiring.
There are a few ways to safely hook a generator into the house wiring. I opted for a somewhat unusual transfer switch that powers six house circuits and can shed loads on an as needed basis to avoid overloading the generator.
I also acquired another identical Honda generator on Craigslist a few weeks ago because these units are designed in a way that two can be hooked together to provide 4000 watts.
So now I have a pretty flexible setup. I can hook both units together or use them separately... here or wherever needed.
The current setup has the generators placed on some shelves in a fenced in area at the side of our house. I use this area for chainsawing and storing the bucked wood.
It's been fun figuring out the evolving configuration. Which equipment to acquire, how to modify the shelf height, how to make the setup weather resistant (yay a tarp and rare earth magnets!)
Those that know me, know that I prefer to go down the less traveled technology roads. If it's offbeat, and a good idea, that's where I'll head.
So in case you missed the link at the beginning of this thread, here's the video of the current the setup. I hope you find it entertaining



