Better, but I still think it's sort of flat...
steven antonucci
through the middle. I would also raise the bottom of that long cove slightly towards the top. if you can remount it, you might be able to sand it to final thickness.
my .02
Steve
Knowledge You Can Build On — Est. 1998
Better, but I still think it's sort of flat...
steven antonucci
through the middle. I would also raise the bottom of that long cove slightly towards the top. if you can remount it, you might be able to sand it to final thickness.
my .02
Steve
this one is good!
Much better "flow dynamics" Ellis! Follow ....
JamieDonaldson
... the profile line of the vessel up into the finial with as little interruption of the major line as possible, meaning squares or reversals that change the line of sight to the tip. This tip could be a bit smaller on future projects, but don't chew this one to death with modifications. Hard maple, dogwood, and similar tight grained woods are my preference for finials, especially practice work, and a 3/8" spindle gouge with relieved heel bevel is a weapon of choice.
I agree
Ellis Walentine
Duly noted, thanks. I had a heck of a time trying to sand that curve fair. Finally I settled for "close enough."
Cheers,
Ellis