Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Star Nebula?

Posts

Star Nebula?

#1

Star Nebula?

david

Posted a shot of this piece as it came out of the soak a little while back. When finished, the stain was not very prominent, so I hauled out my Graeme Priddle wood vaporizer and, following the outline of the stain pattern, burned a random cross hatch on the inside, and a unidirectional dash pattern on the outside. Light source from behind is needed to show the translucence. Cook Pine, 21" in diameter, 4" tall.


Re: Star Nebula?

#2

Mike Stafford

Re: Star Nebula?

Mike Stafford

First impression is that it is a silhouette of a scorpion....or a spider but if you say it is a nebula I won't argue with you.

Nice work!

Re: Star Nebula?

#3

Re: Star Nebula?

Randy Gleckler

Very cool love the design you were given and enhanced. Nice work

Re: Star Nebula?

#4

Steven Antonucci

How thick is it?

steven antonucci

I found that NIP does a great job at transmitting light. I have my guess, but I wondered if you've calipered it?

S

Re: Star Nebula?

#5

Re: How thick is it?

david

I just measured, and it is 3/16" to 1/4" thick. Not bad for this size, as just the weight of the cantelever can be an issue when the piece is wet. As it is, I cannot remove the tenon on the first day, as the pressure of the live tailstock can punch through the bottom--have to wait until the wood is harder and more dry. Vacuum chucking doesn't work because the wood is too porous.

Re: Star Nebula?

#6

Re: Star Nebula?

david

Would agree on perhaps a spider if there were just one more "leg". :)

Re: Star Nebula?

#7

Steven Antonucci

I was right

steven antonucci

It looks like it would be much thinner, but I know how well NIP transmits light, so I knew it was probably around 1/4" or 200/1000ths. When I cut a hat, I aim for 50-80/1000ths.

Awesome use of the material.

Steve

Re: Star Nebula?

#8

Put plastic wrap on for vacuum chucking

john lucas

David when vacuum chucking something that thin with holes here's a trick I use. First I make a vacuum chuck that is 4" wide and 8 or 10 inches long. This way I only have to hold the bottom and don't have to worry about collapsing the whole vessel. then I tape plastic wrap around the area outside the foot. The vacuum will pull the wrap tight against any holes and seal itself.

Of course if the bottom where you are going to turn has holes this won't work but it has worked for many times to cover up bug holes.

Re: Star Nebula?

#9

Re: Put plastic wrap on for vacuum chucking

david

Thanks for the tip, John. I have also used end grain sealer, which leaves a problem of how to clean off the wax later, but it does help.