Thanks
Bill Howatt
"All woods won't produce a surface that clean and some actually tearout more with the skew"
Thanks for mentioning that, I always thought it was me!
Bill
Knowledge You Can Build On — Est. 1998
Thanks
Bill Howatt
"All woods won't produce a surface that clean and some actually tearout more with the skew"
Thanks for mentioning that, I always thought it was me!
Bill
Re: I have one of those stashed away ......
Fred Holder
Mine has been stached for quite a number of years. I purchased it at the 1992 Joint AAW/Utah Woodturning Symposium in Provo, Utah. It was a useful tool, I wish I could remember the Companies name that made it.
Something like "stabilizer?"
JamieDonaldson
Re: Something like "stabilizer?"
Nissan Teman
It is called "Stabilax" and was made by Beech Street Toolworks, which was located at 440 Beech Street in Los Angeles years ago. I have no idea if the company is still there and if the Stabilax is still available. It actually works and I have loaned mine out to several friends over the years and it helped them overcome their fear of the skew to the point where they were able to remove the Stabilax and use the skew without it.
Re: Something like "stabilizer?" *LINK*
Alan Zenreich
Searching Google for Stabilax resulted in an interesting writeup (by Ernie Conover) from 1990
I don't know if pasting the link will work here, but let's give it a try
Stabilax review
Re: The Taming of the Skew
charlie belden
I use skews - a LOT. Until I was shown how to put a curve on the cutting edge, pulling that nasty long point and bottom "heel" corner back out of the way - my skew was the catchiest tool I had. Great spiralling tool though.
One my skews had been modified from straight to curved tey became my FAVORITE tool - initally for spindle turning on small stuff - and very small stuff - and later for lidded boxes and finials. It'll cut, peel AND scrape (like a "negativie rake" scraper).
Two things that make using the skew easier and less twitchy to use when cutting V-grooves and rolling beads are.
1. Making Stop Cuts at where the bottom of the bead or V-groove will be. That would discourage my catching the cutting edge - actually I use the long point - on the "far side" - the "uphill side" of the cut. Cutting UP HILL is a sure fire way of initiating a spiral cut.
2. The other trick was tool handle end hand orientation at the beginning of a roll cut - for a bead. If you start a roll cut with your handle end hand oriented with your thumb ut - the flat of the skew horizontal, and roll the skew so the cutting edge is vertical at the end of the cut and your thumb pointing LEFT (or right if you're rolling the other way) - your wrist ends up in an akward and uncormfortable position - at the most critical part of the cut.
If you start the roll cut with your palm up, thumb pointing the the left for a right rolling cut, or the the right for a left rolling cut - you end the cut with your thumb pointing up - and your wrist in a comfortable "neutral position"
You want to be cutting "down hill" - down INTO a valley created by a V-groove - with a deeper "stop cut" at the bottom of the valley. As you roll down into that valley, the cutting edge is going from horizontal to vertical. If, at the end of that horizontal to vertical transition, the cutting edge gets on the "uphill" side of the valley - you get a spiral cut.
I've done an animated illustration of this OOPS problem which I'm including - that I hope works.
This is how a roll cut works - for me

And this is why a roll cut can turn into a spiral cut

(sure hope this works)