Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Glaser Screw Chucks

Posts

Re: Glaser Screw Chucks

#26

Steven Antonucci

Oneway screw (for a chuck)

steven antonucci

It appears that CSUSA sells a much sharper screw than what I have in my Nova kit, but it is still meant to be held in a chuck. Depending upon what jaws you have it, I am guessing that you have between 2-4" of circumference supporting the workpiece. The only difference from the normal setup was that the screw appears to be deeper threaded and available outside of a chuck kit.

S

Re: Glaser Screw Chucks

#27

Re: QA and QC *LINK*

Stuart Johnson

This is the one I use very regularly. No problems whatever.


Screw Chuck

Re: Glaser Screw Chucks

#28

Knock off, or new and improved?

steve worcester

JT Turning tools showed a glaser type screw chuck at the symposium with a huge improvement, larger tommy bars. My biggest complaint about the Glaser.

It uses a 3/8" bar, the rest looked identical and with fantastic machining (visually). With these chucks, even if the screw is jacked up and running out of round, the wood is butted against the face and it run perpendicular to the lathe beds, so it runs true.

http://www.jtturningtools.com/versasystem

I don't have one, I have a Glaser, but this would seem to be an upgrade to it, just not black oxided, which aluminum doesn't rust anyway.

I would still like for them to make a place for a large wrench on them so I don't have to rely on a tommy bar alone to loosen the chuck.

Re: Glaser Screw Chucks

#29

)

Stephen Mushinski

Thanks Wally - Wonderful to see your words of wisdom on woodcentral again.

Re: Glaser Screw Chucks

#30

Bill Blasic

Re: QA and QC

Bill Blasic

Stuart,

I use this one too, works great! I also use the screw for my chucks and have never ran into a problem.

Bill

Re: Glaser Screw Chucks

#31

Re: Glaser Screw Chucks

David DeCristoforo

Ooo... Hot item. Seems like every time a tool is discussed the sparks start to fly! But I can't resist throwing in my 2 cents worth. I have one of the "original" Glaser chucks and I have one of the new ones. All I can say is I'm sorry I only have two. The old one has a steel body which I like better than the new alum. ones. But the new ones with the additional backing plates are really nice. They hold like no other screw holding system I have tried so far. The Nova wormscrew is crude (MMHO) compared to the Glaser screw. The several faceplate screws I have wasted money on are not much better than using a drywall screw.

Re: Glaser Screw Chucks

#32

With David here

John Cotten

I have turned 20" + bowls and platters on my Glaser chuck. I have the aircraft Aluminum model, and love it. Got misplaced for a period of time, and I searched ebay for 3 months solid looking for another one. Found my old one, and now have two. Love them. Another tip, if you have a uneven or natural edge piece you are going to turn into a large bowl, take off the wide plate, and counterbore a 1-1/4" hole in the face (I think that is the size of the od on the Glaser chuck, may need to adjust the size) then drill your 1/4" screw hole, will work fantastic to do the outside and turn your recess or foot for your lathe chuck.