Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

What's it called and where do I get one

Posts

Re: What's it called and where do I get one

#26

Re: Oneway adapter ordered!

Carol Reed, Strawberry, AZ

According to the catalog, it is 3/4" x10 TPI and I measured my live center. Good to go. I also got a cup center, which was missing from my used purchase of the live center, and a threaded insert for one of my chucks. Priority mail. Ought to be here in first part of next week. Don't have time to play with it until then in any event.

Re: What's it called and where do I get one

#27

Re: What's it called and where do I get one

woodspinner-harry robinette

John

For doing spindles I use a LIVE DRILL CHUCK I got mine from The Little Machine Shop but PSI has them

I put mine in the tail stock and a piece of wood into the lathe and let it run for about 1/2 hour to loosen it up. Now I use it like you said for small spindles.

Re: What's it called and where do I get one

#28

Mike Peace

Low cost solution for 1" X 8 chuck

Mike Peace

Penn State has this for $12.38 incl shipping thru Amazon: PSI Woodworking LA341018 Headstock Spindle Adapter (3/4-Inch x 10tpi to 1-Inch x 8 tpi chuck) by PSI Woodworking. May not be the best solution for a Jet 1642 or PM3520 with a 1 1/4 thread for the chuck but is a low cost solution for those with a mini lathe and a live center with a 3/4 X 10 threaded live center.

Re: What's it called and where do I get one

#29

Re: Information.

woodspinner-Harry Robinette

I know my Oneway live center is 11 years old it has a 5/8" X 10 tpi.

Re: What's it called and where do I get one

#30

Re: Information.

Bob Edwards

I'm on vacation at the moment and out of state soI'll have to wait 'till I get back home to measure but my Oneway live center is 20+ years old and less than 5/8.

I told you I was an old codger!!