Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Multi-Off-Axis Elm Hollow Form

Posts

Multi-Off-Axis Elm Hollow Form

#1

Multi-Off-Axis Elm Hollow Form

George Guadiane

I did a demo on this at Totally Turning. At the end, I cut this piece off of the tenon (wish I hadn't done that), to show how I would do it.

The outside is all done between centers, mostly with scrapers. No special chucks or other fancy gear.

There are 3 outer axes in addition to the center. Ths was created by aligning the axws A/B - B/C - C/A in a series of re-orientations so that I could make the sides close to equal looking.

Eventually, I'll do a series of them, but they need to be hand sanded and wood selection is important, because if you get a lot of tear out, you'll never get a decent finish.

I sanded each side then applied some water based poly and sanded with the next finer grit. This is sanded to 400 with one coat after that.

4 1/2 inches high.

Re: Multi-Off-Axis Elm Hollow Form

#2

Re: Multi-Off-Axis Elm Hollow Form

David Walser

Very cool. Thanks for sharing.

Re: Multi-Off-Axis Elm Hollow Form

#3

Re: Multi-Off-Axis Elm Hollow Form

Ron McKinley

I really like that shape.......Ron

Re: Multi-Off-Axis Elm Hollow Form

#4

Forgot to point that out!

George Guadiane

Thank you!

When these pieces are spinning on the lathe, from the center axis and I look at the "ghost" form, I was trying to make a pleasing shape.

Its more difficult to see when its not spinning.

Re: Multi-Off-Axis Elm Hollow Form

#5

Chuck Jones - West TN

I like that

Chuck Jones - West TN

It prompted me to try one this morning. I had some trouble sorting out which ghost I was looking at so I didn't get all three sides as equal as I would like, but it was still fun and not bad for a first try. I've been deferring multi-axis attempts for a while now. Thanks for the motivation.

Re: Multi-Off-Axis Elm Hollow Form

#6

Re: I like that

George Guadiane

Here are some pictures of the blanks and how I set them up so that I can get more even sides:



I use the colors so that I don't get confused about which axis goes with which on the other end... Match the color and you're good to go.

The cut in areas are so that I can match the depth on all three sides. Cut in far enough and they disappear. I usually cut a second deeper set for refining the form.

Re: Multi-Off-Axis Elm Hollow Form

#7

Re: Multi-Off-Axis Elm Hollow Form

Don Orr

This piece is even nicer in person ! And seeing the demo makes it look easy-but it's not. It takes great care and patience to get them to come out this nice.

Well done George.

Re: Multi-Off-Axis Elm Hollow Form

#8

Leo Cuellar

Very Nice...

Leo Cuellar

George! I really like the way you dealt with neck on this piece. Gives it a nice twist :D

Re: Multi-Off-Axis Elm Hollow Form

#9

Thank You To Everyone   

George Guadiane