Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

sharpening jig

Posts

Re: sharpening jig

#26

Re: Can't see how this happened

David Walser

John, doesn't where the tool strikes the wheel also depend on the overall length of the SRG and not just the desired bevel angle? I have a 2" SRG and a 3/4" SRG. The larger SRG is also almost twice as long as the smaller tool. Since I cannot move the V-arm closer to the floor, it seems to me that the two tools would have to strike the wheel in different locations to obtain the same bevel angle (assuming both are mounted with the end of the handle in the V-arm).

I'm away from the shop so I cannot verify what my intuition is telling me -- so, as usual, I may be way off base.

Re: sharpening jig

#27

Re: sharpening jig *LINK*

David Walser

...I like the flat platform although I modified mine. I milled a slot across it like a miter slot. This lets my homemade skew sharpening jigs slide sideways. It is a big improvement over the oneway skew jig I think. I have one for my oval skew and one for my flat skews. This keeps the bevel consistent. With the Oneway skew system it's very hard to keep the bevels consistent. ...

Take a look at Sharp-Fast's platform. It comes with a slot already milled in it. Sharp-Fast's skew jig fits in the slot and slides sideways. In addition, IIRC, Sharp-Fast's SRG jig also uses the slot.

I've not had a chance to use Sharp-Fast's complete system (with all their jigs), but their video with Dave Hout shows that they've made several improvements on the Wolverine system. I still think I prefer Woodcut's Tru-Grind system (for the reasons cited in my post, above), but I think the Sharp-Fast system is worthy of serious consideration.


Sharp-Fast's SRG and Skew Jigs

Re: sharpening jig

#28

Sharpen without the handles

Jorge Casta�eda

Dave,

Due to lack of space, I started sharpening without the handles, I found out that getting good results is a lot easier and the same setting is good for all my gouges.

Then the Thompson tools came along and now I sharpen all my tools with no handle.

Besides ease on sharpening, you can use different handles as well, short, medium long...

Re: sharpening jig

#29

Re: sharpening jig

Bill Neddow

Steve, the new Wolverines will not go off the stone either.