Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

*** SURVEY: THE IDES OF MARCH *** *LINK*

Posts

Re: *** SURVEY: THE IDES OF MARCH *** *LINK*

#26

Re: *** SURVEY:  THE IDES OF MARCH ***

charlie belden

I've been holding an 8 foot long board and had it slip in my hands - and got cut by the sharp corner edges.

Stuck mortising chisel coming loose suddenly and hitting a chin or between the eyes? Yes.

Catch a falling sharp bench chisel? Yes - but got luck and grabbed the handle.

Things getting in my eyes? No - but I have a pair of glasses with dots of CA glue on them - that would have gotten in my eyes had I not been wearing safety glasses.

Brushing off splinters with a bare hand? Yes, semi-often.

Contact with sharp spinning things? NO - but only because I'm a bit paranoid about it happening - so I use the GRIPPERRRRR, push sticks, hold down, hold ins and when routing parts hand held - clamp the piece down.

Had a piece of stock I was hand feeding to a 7" diameter cutter head spun by a 3hp motor shot 20 feet down my driveway. Haven't got a good power feeder yet - so I don't use the shaper.

Out of total ignorance, I did try and rip a board with my 12" sliding compound miter saw. If you think a kickback on a table saw is dangerous, try having the stock semi-fixed - and the saw kicking back. The thumb on the hand holding the saw wasn't broken - but it was sore as hell for a week or two. Thank the gods that the piece of the board that took off at Mach 6 bounced around for a while and was never found.

Have abraded off the finger tips of two finger tips - both on the Tormek's wet, 50 rpms wheel AND on Japanese water stones.

Been hit - a few times - by a long board that was leaning against something precariously.

I've had a bandsaw blade snap - and accordian into the blade guard. Didn't require changing pants and or shorts - but it took a while to get my heart rate down.

If I have to do repetitive operations, I'll do some, go do something else and come back and do a few more. Changing tasks, while not the most efficient way to do things, helps keep you focused on each one.

After a stuck mortising chisel handle nailed me between the eyes I put a band aid on it and went back to finishing the mortise. When you're swinging a mallet towards a mortising chisel - a drip of blood is distracting as hell. Yes, the mallet missed the chisel and hit the hand holding it. Fortunately the blood on the wood was covered by the shoulder of the tenoned part.

Re: *** SURVEY: THE IDES OF MARCH *** *LINK*

#27

Where is that sharp edge going to go....

Dave Belser

If I slip?

You'd think that I'd learn this one, but I've been bitten three times. As others have pointed out, a tool doesn't have to be powered to be dangerous.

First time - trying to change a yo-yo string with an Exacto knife when I was supposed to be getting ready for school. Drove the knife firmly into my palm.

Much later - trying to clean up the bottom of a freshly turned slippery bowl with a bench chisel. Drove the chisel firmly into my left index finger.

Third time - Honing the inside of a 5/8s bowl gouge. Left two nicely parallel slices on my right wrist, the scars look like I attempted suicide.

All three should have required stitches, but I was able to get away with butterfly bandages on the wrist. As a side note, have you ever tried band-aid two slit cuts on your wrist without assistance?