Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

A mans gotta do what a mans gotta do with the skew

Posts

Re: A mans gotta do what a mans gotta do with the skew

#26

Leo Cuellar

Had to split this post...

Leo Cuellar

As I kept losing the first 2 pics.

Next, my "secret" weapon. A 5"(125mm) 4 fingered chuck...



Scribing accurate center lines is a must, for lining up your centers on the chuck...



First of course general shaping...



For this size chuck you can only use a max width of 3.5"(87.5mm). The length of the stock is 10"(250mm) as with the offset for the bowls that is the largest I can swing on my lathe.



then flipped backwards & centered to do the gross shaping of the back side. Then offset to do the outside of the bowls, with each bowl on the jamb chuck, as per the first post. Just as you would do, but with the extra length to look out for.

I had the idea rattling around in my brain pan and had to get it out :D (it was making a lot of noise) As we discussed, my lathe really isn't up to a task like this. I'm not a pilot, but it felt a little like trying to land on a carrier during a hurricane. Lathe bouncing, me bouncing... :( :O

I'm sure your Stubby will make easy work of it :)

Re: A mans gotta do what a mans gotta do with the skew

#27

Re: Had to split this post...

Terry Scott

Leo I use conventional chucks but take out 2 sets of Jaws works a treat