My newest and most favorite ugly stick...
Mike Stafford
Mike Hunter sent me some adaptors that were designed to fit into schedule 40 PVC pipe. They work very well in that application for most tools. However my wife gave me a new P&N spindle roughing gouge and I wanted a little more heft in the handle so I took a piece of gnarly old oak I had in the shop and turned a handle with a 1/2" adaptor in one end and a 3/8" adaptor in the other. I had to hollow the end grain to make the adaptors fit since the ID of schedule 40 must be an odd size as I could not find a Forstner in my inventory that would work. After achieving a snug fit I glued in the adaptors with epoxy and used the adaptor hole to drill the hole farther into the wood so I could vary the projection of the tool if I wanted.
On the reverse side there are two Allen set screws tapped through the wood and the aluminum which hold the tool shaft firmly in place. I finished the wood with multiple coats of CA.
I love my new P&N spindle roughing gouge and I love the heft of my ugly stick handle. It ain't pretty but it sure does a number on box blanks. 


It is possible that I may have even more hammers than John. Two of my favorites are the adjustable open end hammer and the ratcheting hammer 


