Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

A table saw users Christmas present? *LINK*

Posts

Re: A table saw users Christmas present? *LINK*

#26

Steven Antonucci

Reclarifying my point

steven antonucci

I wasn't suggesting that the SawStop was a bad idea or a bad saw. On the contrary, I was pointing out that there was a deliberate attempt to influence the outcome of the demo. There is no possible reason that I can see anyone would ever dunk their hands in a bucket of icewater before making a cut on the saw, so it was done with a purpose.

It is basically done to increase the sensitivity of the trigger circuit to minimize any damage from accidental contact. I assume that if you had warmer drier hands, it might allow 1-2 more teeth to make contact, which would make for something you couldn't show to a primetime audience.

I would like to see a disclaimer in that demo that explains why he is doing it. At the end of the demo, he is completely unhurt. I think it's a bit unfair to suggest that this device ELIMINATES any potential chances of being cut, and even worse to intimate that it eliminates all risks at the tablesaw.

That said, I have seen the SawStop, and I believe it is a very good saw with some additional safety features that lower certain types of risks of injury. The SawStop also has saved 100's from an injury that they should never face in the first place... touching that sharp spinning thing!

S

Re: A table saw users Christmas present? *LINK*

#27

Keith Tompkins

Re: Reclarifying my point

Keith Tompkins

Wonder what would happen if the user was wearing gloves? Seriously, there really shouldn't be lawsuits involving whether or not a saw had the saw-stop capability....the person involved in the accident may have deliberately chosen NOT to buy the technology.

Re: A table saw users Christmas present? *LINK*

#28

Re: John, I have a question.

JohnKyler

Keith,

Because a dado is 8" in diameter you replace the standard 10" brake with a dado brake cartridge. It is wider and thicker. The brake cartridges are of a honeycomb design and have a crumple zone (like a car) that when actuated, causes the blade to embed itself deep into the aluminum. The inertia from the blade spinning, digging into the brake causes it to stop, drop and well not roll but you get the point. It all happens so fast (less than 5 thousands of a second). I had a new customer change out the cartridge and re-set the saw for operation and it took him 8 minutes from start to finish.

Re: A table saw users Christmas present? *LINK*

#29

Re: It works like they say

JohnKyler

John, I can see where someone might be complacent. But I can say I hear where some are having a senior moment, distraction, one was even where someone bumped his hand into the saw. The last one where an employee bumped his hand into the blade, still denies he needs a SawStop. Sadly his fingers had 20+ stitches and a lot of pain for months and lost time from making money as a small shop owner. He bought another brand saw even after the accident. His fingers still bother him.

I will also say that likely those that would become complacent, would do also with an obsolete table saw with no safety feature. They would still have fingers and a bunch of blades trashed into brakes to hang on the wall though.

I recall a guy telling me "no, don't need one, I'm very careful" standing there pointing at the SawStop with a stubby finger. I asked what happened to your finger? It wasn't a table saw, I got it into a V belt.

And Steve, as for push sticks and feather boards, they are great, and should be used (with blade guards, and riving knives)... But a good kickback with the force to throw a board across the room and into the wall, could cause the pushstick to kick out of ones hands only to catch a finger(s) in the blade.