Worth a Look, New Calipers at LV
Jim in River Oaks, Ont.
Hi,
I just saw these on line at LV, they are a limited buy and worth a look, the price is reasonable.
Hope some of you find this useful, I just ordered two sets.
take care,
Jim
Knowledge You Can Build On — Est. 1998
Worth a Look, New Calipers at LV
Jim in River Oaks, Ont.
Hi,
I just saw these on line at LV, they are a limited buy and worth a look, the price is reasonable.
Hope some of you find this useful, I just ordered two sets.
take care,
Jim
Re: Worth a Look, New Calipers at LV
Dick Coers
Can you post a link? I couldn't find them on the site. Thanks
Re: Worth a Look, New Calipers at LV *LINK*
JL
Calipers
By the way Jim, if I get in trouble with the LOML.
JL
I'm going to tell her that you tempted me. Well, so did Lee Valley with their special limited purchase..
Re: Worth a Look, New Calipers at LV *LINK*
Denis Putland
Hi
I bought the two as a set from Craft Supplies USA $45.00 total.
Denis
http://www.woodturnerscatalog.com/store/Measuring___Calipers___Digital_Inside_Outside_Calipers___digital_io?Args=
Re: Worth a Look, New Calipers at LV
Jerry Klug
I have the OD model and use it often when turning. Be advised that the measurement is to "hundreths of an inch" (0.01"). If your arre needing a finer measurement, say for a snug fit for a snap fit box lid or a jamb chuck, I use my dial caliapers that measure to thousands (0.001").
I was not specific on this item so---
Galen Vetterick
I got the LV ad and there was no mention of materials of construction. They looked like plastic so I ask LV. I was not specific enough so the reply email said they are made of SOME die cast, plastic and steel parts. Dah! I should have ask if the jaws were metal as I could see the dial/gauge was plastic.
I see the Craft Supply say their version is chrome plated steel.
I learned my leason to be more specific but why don't more tool descriptions cover the materials of construction?
That said:
I bought some calipers from PSI a while back as they did say they were stainless steel. When I got them they were plain steel. The reply from PSI was the ad was wrong and they would correct it for FUTURE sales.
No more purchases to PSI.
End of rant.
I have tried them, and while they work OK
david
They give the kind of accuracy I don't need or perhaps want. All I want is a caliper that reaches far into my pieces, and gives me relative thickness to tell me where I need to remove more material. Sales rep asked me to use them while I was doing a demo at a Woodcraft tent sale event. There is another version with a straight leg and a curve in a "D" shape. Guy also said there was a larger version in the works too. Keith Tompkins' Gage 'It is fast and simple to use and gives me all the information I need when turning my vessels--use it all the time.