Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Oneway recommends 3450rpm 8" grinder?

Posts

Re: Oneway recommends 3450rpm 8" grinder?

#26

Re: Aluminum Angle Standoffs

Bill Grumbine (Kutztown PA)

>Al, I did see that, and am waiting for my second base to arrive. I'm not sure I am following your aluminum angle set up though, so if you have any details, I would be grateful to see what you are thinking.

Re: Oneway recommends 3450rpm 8" grinder?

#27

Re: Tormek plus hs grinder

Tommy Holmes in NW FL

>I have the same setup Bill. I mounted the Tormek support on the side of the grinder per instructions and then mounted the Wolverine jig with the locking lever behind the grinder. I did this a few weeks ago and it has worked well.

Re: Oneway recommends 3450rpm 8" grinder?

#28

Re: Tormek plus hs grinder

Bill Grumbine (Kutztown PA)

>Tommy, that thought had occurred to me. Is the arm on the platform long enough on yours that it can still lock down with the levers behind the grinder? I have not measured anything out yet, but that was my first thought of an obstacle.

Re: Oneway recommends 3450rpm 8" grinder?

#29

Re: Tormek plus hs grinder

Tommy Holmes in NW FL

>Bill, I haven't had any problems with the arm being too short. It goes all the way through and locks nicely. I use the Wolverine jig for gouges so the "V" pocket sits pretty close to the wheel. I like the Tormek jig to sharpen skews so I haven't tried a skew that would put the "V" pocket a lot further from the wheel.

Re: Oneway recommends 3450rpm 8" grinder?

#30

Don Geiger

Re: Oneway recommends 3450rpm 8" grinder?

Don Geiger

>I don't know how to post a photo on this site. My Wheel Truing and Dressing Solution, with prices, can be viewed at www.geigerssolutions.com.

Don Geiger