I use three Luxo-type articulated arm lamps that I put 60w clear glass incandescents in. Of course, I only use as much light as I need at any moment to keep the KW consumption down.
I don't like the diffused light put out with frosted incandescents or CFLs when it comes to seeing those tiny sanding scratches.
>As discussed here often in the past, a wide, diffuse light source is great for general work but is certainly the worst for seeing scratches.
The easy thing I do for point-source lighting to see scratches - keep all the lathe task lights except for one on a single switched outlet strip. When sanding I often switch those off and leave the one on. The small halogen spots are good for this (look above the counter in nearly any jewelry store). Another very useful thing is one of the new ultra-bright LED flashlights which has a very small source and is easy to move (for inside, as well).
I also keep a swingarm light on a magnetic base on the back of the lathe, down low. This is great for a glancing light when sanding. I learned long ago while exploring caves that a light source near the eyes (i.e. headlamp or over-the-shoulder) is very flat and not good for showing detail (texture).
My experience with CFL's has not been good. They are not bright enough to suit me. My reason was asking the questions was to learn what experience others have had.
Intuitively it would seem that the coiled bulb on the CFL would accumulate dust more readily. Based upon the amount of dust that seems to settle on an incandescent bulb that is not a good thing. I have also heard that they don't last as long when used "bulb down"; supposedly horizontally or bulb up as in a lamp they have good longevity.
It seems it will be the only lamp available besides LED in the future. I don't eagerly await using CFL's in the shop.
>Just passed through the local Lowes store. To my surprise, they have the LED bulbs that screw into ordinary sockets. They had about five ranging form $39.95 to about $65. They had many more CFLs.
It appeared to me that the LED bulbs operated at 2700 K. They seemed to use about 2/3 the power of the CFLs and actually put out less light as rated in lumens. The were rated to lat 25,000 hours while the CFL's lasted 8,000. So, a CFL was abut $5 and it would take three to last about as long as one $40 LED. The LED would use 7 watts and the CFL would use 11 per hour. So, if I understand a savings or 4watts per hour for 25000 hours is 100,000 watts or 100 kw and at $.10/kw that's $10. That still leaves you $15 in the hole.
There would be other factors. The color of the light, the pattern or distribution of the light, The difficulty in changing the bulbs etc.
>to look as the number as the top half of a fraction, with eight as the denominator. The industry standard is to express the number in eighths. The term PAR 38, for instance: The acronym PAR stands for parabolic aluminized reflector, and the number 38 is the diameter of the lamp in inches...38/8, or 4-3/4" in diameter.
>I am using three Ott lamps in my basement shop. Two are 300W equivalent (drawing 65W) and one is 100W drawing 25W. It is directly above the lathe. The other two provide general lighting. They take a few minutes to come up to full brightness but then the shop feels like it is outside on a bright day. I sometimes use another 100W Ott on a flexible mount for detailed work.
The large bulbs just hang in space and do accumulate dust, but they are so cool (temperature wise) that is is easy to wipe them off while on.
>That is my main beef with fluro, they not only save electricity, but they sell them in minimal wattages. All of a sudden I have started seeing LED light bulbs, roll on the day!!!.
I have been wondering whether LEDS also have the strobe safety issues of Fluro? I assume not...