Tip
dwr
>
Knowledge You Can Build On — Est. 1998
Tip
dwr
>
Re: There's the problem in ....
Jamie Donaldson
>... plain sight! The wings on each side of the tip extend even with or beyond the tip, creating a large cutting surface without benefit of bevel rub- very grabby!! You have been grinding away too much of the thin area in the tip. Grind back the wings on each side of the tip so that there is a continuous straight (or only slightly convex)cutting edge without the lobes on each side, and the catches will be gone like magic!
Ouch!!...That Looks Grabby......
Wally Dickerman in Arizona
>Should be a dome instead of a trench...
Wally
I think I ...
dwr
>... know what you are saying. I will re-grind this afternoon and then re-post the same pictures and see it I got it right.
Thanks,
Dave
Wally...
dwr
>... think I understand about the "trench." The head on view of the tip should have the wings at or below the cutting edge of the tip, not riding above the edge... right???
Can you post a picture of your gouge at a similar angle so I can get a "visual" as they would say in WWII;)
Thanks,
Dave
Jamie ....
dwr
>Can I con you into posting a picture of your gouge from the same angle so I can see the direct comparison? I will be back later this afternoon to re-grind my soon to be shorter Thompson Tools...
Thanks,
Dave
Re: Look in the "Grinds Library" *LINK*
russ Fairfield
>The first two sets of photos by Terry Daniel and Ellis Wallentine will show you what it should look like. One has a longer side grind that the other. Otherwise they are the same.
Grinds Library
Re: Dave- as Russ posted, .....
Jamie Donaldson
>...there are several images in the grinds library that illustrate the point point!
Re: Ouch!!...That Looks Grabby......
Wally Dickerman in Arizona
>Dave, my gouges look almost exactly like the first 3 pics in the Tools Grind Library.
Wally
Re: Ouch!!...That Looks Grabby......
russ Fairfield
>And mine look like those under my name farther down the list.
Re: Jamie ....
Doug Thompson near Cleveland
>Dave, they won't be much shorter. You have good advise so far... grind the wings then create a round nose. There isn't too many ways to grind a V shape tool because the grind follows the flute shape. Stick to the basic shape, it works very well.
The 6 inch grinder doesn't matter at all.
Post another picture latter on tonight.
Re: I'll have to try that
Ron in Drums PA
>A rectangle one for the outside and a curved one for the inside.
It really works better on the outside though