Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Oh dear, the General is making funny noises!?!

Posts

Re: Oh dear, the General is making funny noises!?!

#51

Re: Picture !!!!!!!!!!

Ruth Niles

>Mac, that might be closer to reality than you think! I was wondering about that warning with the use of the screwdriver: "Don't put it near any moving parts".......... was he referring to the General's moving parts or mine?!? : )

Re: Oh dear, the General is making funny noises!?!

#52

I Had That Problem So Now I Use Suspenders Instead

Ken Oakley-Sunny St. Cloud, Fla.

>

Re: Oh dear, the General is making funny noises!?!

#53

Re: Picture !!!!!!!!!! *LINK*

Wilford Bickel

>Ruth,

I have stayed out of this because I really don't know the makeup of the Generals. (Plus I have been laughing too hard!!) Check any nuts that are holding the spindle and/or the bearings in place and make sure you did not loosen them with the pressure and heat you put on the faceplate. If you did loosen one just slightly it could be letting the bearing bind. Also checking the belt to make sure it is not coated with one of the oils is a good idea as stated above.

If you do have to replace the bearings check out Motion Industries. They have a local store here and I get all my bearings from them for the farm and wood shop. Even strange metric sized stuff for the imported tractor! They list something like 7 locations in PA - one should be near you. Just pull the bearings out and take them along with the spindle to them, they can work off the numbers on the bearings and the measurements and fix you up with GOOD bearings much cheaper than a machine supplier!!


Motion Home Page

Re: Oh dear, the General is making funny noises!?!

#54

Doesn't anyone here live close to this senorita? *LINK*

Eddie Pacheco, San Jose, Ca.

>I'm certainly not at all familiar with the Pennsylvania area, but I would have to think there is someone, male or female, close enough to do a drive by to go help out.


http://maps.google.com/maps?f=q&hl=en&q=49+Leeds+Rd.+Newville,+PA&sll=40.133741,-77.34581&sspn=0.186626,0.31929&ie=UTF8&om=1&z=16&iwloc=addr

Re: Oh dear, the General is making funny noises!?!

#55

Re: Ruth ---

Wayne Allen - Carson City. Nevada

>I had the same experience as Jake regarding the replacement of the bearings. It seems as the spindle bearings on the General are getting somewhat notorious for going bad, as many others attest. But, no worries, as Jake said the bearings are fairly easy to replace and they are most probably available at a local shop. I went to a local machine shop supply and paid about $3.00 for each for the sealed bearings (2 required). I just brought the spindle assembly down to the supply shop and the guy matched the bearings. Even if you don't want to fuss with getting the bearings off the shaft and putting them back on, the guy at the machine shop will probably do it for a few bucks. It really was no big deal and It sure did make the General run quieter. It really was a cheap fix for what I origionally thought was going to be a major problem. --- Wayne

Re: Oh dear, the General is making funny noises!?!

#56

Re: Run it and check....... how long?

Jake Niedling

>Ruth - It sounds like it should be fine. Because when a bearing goes bad it will generate heat. Go ahead an turn something and then check the bearing area and the shaft. A little warm is ok, but more than that indicates a problem. You really won't hurt anything but the bearing until you replace it.