Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Pros and cons of your lathe

Posts

Re: Pros and cons of your lathe

#51

Re: Sounds like a great lathe...

Bob Fawcett

>I'll look forward to the write up.

Thanks.

Re: Pros and cons of your lathe

#52

... like this?

dwr

>... so many choices;)


img

Re: Pros and cons of your lathe

#53

Bright Red...

dwr

>... or like this...


img

Re: Pros and cons of your lathe

#54

Then again, Gold looks good...

dwr

>... too!

Maybe I should tale a "Poll" to pick the color...;)


img

Re: Pros and cons of your lathe

#55

Re: Then again, Gold looks good...

Clay Foster

>I vote for bright red with black and gold pinstripes, a fire truck look.

I made a very similar style lathe once, pillow blocks on a box welded up out of plate steel. Largest thing I ever turned on it was a vessel 40" diameter and 30" deep.

Re: Pros and cons of your lathe

#56

Re: ... like this?

Allen Neighbors

>Looks good to me. :o)

Re: Pros and cons of your lathe

#57

Re: Then again, Gold looks good...

Bob Fawcett

>I like all 3 choices.

That second red may make it hard to see your work though (at least without sunglasses). :-)

Re: Pros and cons of your lathe

#58

Brad Vietje

Same with the newer 3520-B

Brad Vietje

>Since hollow forms are what I like to make most, I wanted the sliding headstock so I could work off the end of the ways, standing right in front of the piece. This works well for bowls, too, eliminating the need to lean over the bed, which really bothers my lower back.

This system works well, and the alignment has been very good. I considered the 1640 with the outboard bed and tailstock riser, but that's getting into some real money. The same setup around the 2036 is even more expensive, and I really wanted to use the cost savings for renovating my house. The PM was the right fit for me.

The negatives are the lack of a good indexing system that's easy to use, and the lock on the toolrest post is nowhere near as nice as the Oneway lock. The 3520 A's had a problem with the tailstock banjo lock being a little soft, and not gripping real well. I think that is due to flex in the metal shaft inside the banjo; the -B models have a different banjo with a beefier eccentric shaft, and it locks well. the offset toolpost can get in the way on smaller pieces. I plan to make a tailstock swivel so its easier to get it out of the way, and bring it back again. Everything else really pleases me, and the machine works very well -- a lot of lathe for the $$$.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Pros and cons of your lathe

#59

I like this one the best.

Brian Hahn in SW Wisconsin

>

Re: Pros and cons of your lathe

#60

Yeah... me too....

dwr

>... It's a two step process that will "bump" the budget a tudge... but then a guy has to do what a guy has to do, right?!

Something about this color stimulates the creative juices... now if I can figure out how to PC wood...

Re: Pros and cons of your lathe

#61

Gold is easier to live with...

Jorge Castaneda

>