Re: Cooper's Jointer
David Weaver
my first long plane was a 28" beech jointer. I'd bought a bunch and was enamored with them. It weighs about 10 pounds and I have to admit I never use it. I could take a picture of it sticking out of the rack from where I'm sitting, but no need. IT's next to some other planes that don't get much use!!
The only hesitation for me with building a coopers jointer is whether or not I'd actually use it. I know if I had it as a plane bigger than the 28" jointer, I would end up not using it as you can blast away with things on it, but in heavy work, it's so heavy in the hand to bring it back during a cut.
re: the fence, and you may see this as a very warren comment, but I often use my metal jointer upside down in the vise (as well as the smoother, etc) for small stuff and would see the fence as making things a little bit more difficult, or in my case resulting in shredded knuckles. I chuckled a little at your comment that warren could joint thin boards in the vise. I think I can, too and the next time I have to joint thin boards, instead of matching them (which is easy with thin boards), I'll plane them individually and glue them and see what the joint looks like.
Side comment unrelated except to the use of the upside down plane - I'll bet this is a vastly underused tool for most people who need to trim parts (especially small one).
Set the double iron on the jointer, put it upside down and it still offers tearout protection and really limits the amount of damage it can do to fingers. necessity for pencil making, too, but I'm sure that's not going to be widely appreciated!




