Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Tormek: getting old wheel off?

Posts

Re: Tormek: getting old wheel off?

#51

Re: same, but details different, and a question

Jonathan Elliott

If I understand it correctly I think Joel is saying he uses a wider wheel with less of a pronounced crown. There is still "point" contact as the blade travels left to right and right to left but the "point" is wider than on a narrower wheel with more pronounced crown.

Re: Tormek: getting old wheel off?

#52

Re: same, but details different, and a question

E Phillip Smith

I use a 1/2" wheel with SHALLOW crown. Probably use roughly half the wheel while grinding. I used to use wider wheel but have found MUCH greater variety of wheels for surface grinders and you can buy 1/2" wheels cheaper than the wider wheels so I opt for the narrower wheels as matter of cost and not amount of crown.

I get the impression from Joel's description that he slightly rotates to iron to take advantage of the full wheel width. As much as possible I keep the iron square with the wheel. That slight crown makes grinding a clean edge dramatically easier. Both variations of the technique will work.