Looks good--coupla thoughts
Wiley Horne--So. Calif.
Hi Roger,
With the rubber pads, the only potential problem I see is over-tightening enough to cause deflection of the drawer side (some like thin drawer sides). If this is an issue for you, you could avoid it by placing positive support under the side being planed. For example, clamp a wide-ish board, a little thicker than the height of the dogs, across the width of the bench. That board disappears into the drawer and butts against the drawer bottom. The support board extends past the bench edge the net drawer depth, which is known to you. This support board would obviate any tendency to over-clamp, and would provide positive backing for the planing.
Procedure: Clamp the support board in place from the offside of the bench; lower the drawer firmly onto the support board, and tighten the edge dogs the Goldilocks amount (which we know from experience
). This would all go quickly in practice, because you already know the projection of the support board over the edge, and would need no adjustment for all drawers of the same height.
There are numerous variations on how support could be provided--the procedure above is one of many possible ways. And it may not be needed either, except in case of 1/4" to 5/16" drawer sides which I like.
Wiley