New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Workbench Question

Posts

Re: Workbench Question

#51

Re: too wide

Lars Parrington

As I see it, the bench can be as wide as you want if you are going to place it against the wall, but it is better to limit the width if it is going to be out in the open. This is contrary to what most people here are saying, so I'll explain myself a bit.

Against the wall, imagine for example a 48" wide bench. Clearly that's too wide to reach across, so you'll end up working only on the front half or so. The back area will either get cluttered with tools or organized into an efficient storage space. Not a problem.

My bench is out in the open. I work from both sides of it, and frequently need to reach all the way across it and often even beyond the opposite side. That is why I recommend limiting the width. Here are some examples of when I need to reach all the way across:

-- flattening the top of the bench, using a #7 plane, taking diagonal strokes.

-- flattening a wide panel clamped between dogs. here i alternate sides of the bench so i am always working with the grain.

-- clamping a board to the front of the bench by clamping across the whole width of the bench. often i want the handle of the clamp on the back of the bench so i am not bumping into it.

-- flattening the bottom of a drawer.

The only time I find myself wishing for a wider bench is when gluing up wide panels in pipe clamps. Not a problem if you already have an assembly table.

Re: Workbench Question

#52

Re: too wide

TomD

Those are good points Lars, which just goes to further show there isn't a required approach. I might follow your approach if I had plenty of room for a bench, but didn't want to have all sides accessible, and didn't have wall mounted tool storage. For me that would be a fail on three points, and I don't think all that many people would fit that mold, but one can't say a bench can't be wider than X, only it can't be wider than X if... A bunch of stuff.

My default has been narrowed and longer, over the years. In one shop I had a bench 16 inches wide and the length of the shop. That was a great bench also.