New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

THE Shop Stool.....the base.....

Posts

THE Shop Stool.....the base.....

#1

THE Shop Stool.....the base.....

roger lance

well, with respect to Wegner & Derek, maybe just a shop stool. This project has been on the back burner for a long time.....a stool to sit upon comfortably while in the shop and perhaps use it at the bench while doing some small part hand work.

I've seen some stools posted on various sites and decided to proceed with a stool of my own even though I lacked a formal plan....so I made a mock-up of the stool base with scrap....


I found if I made a cut at 7° on the ends of my legs using a V block at my miter saw that the legs would be splayed at about 5°.....


Geometry was a long time ago and I'll let anyone that can do the math go for it but these angles worked well. All base joints were mortise and tenon.....


and will be pinned later. The clamped up base was accomplished by using little 5° wedges stuck to the legs with 2 sided tape.....


I'm awaiting some 8/4 cherry or 8/4 walnut for the seat.....I'm told they should be out of the kiln by Monday. So the seat will be part two.

Re: THE Shop Stool.....the base.....

#2

Re: THE Shop Stool.....the base.....

Hank Knight

Lookin' good, Roger. I built a shop stool last year and I've used every day since. You're going to enjoy yours. It doesn't look like the math gave you any trouble. :>)

Re: THE Shop Stool.....the base.....

#3

Re: THE Shop Stool.....the base.....

roger lance

My wood supplier is pushing back the day when I can get some 8/4 walnut from the kiln.....so I've been taking some time to make arrangements for making/fitting the seat. First before base assembly, I pre-drilled the tops of the legs for dowels that will be glued into the seat bottom.....


and made a template of the location of those dowels as an aid to drilling corresponding holes in the seat.....


hopefully, this will insure that the seat mates well with the base.....


the actual making of the seat may be awhile off as the seat material I do get should be given time to acclimate to the shop before being worked.....at least I've heard rumors to that effect.

Re: THE Shop Stool.....the base.....

#4

Re: THE Shop Stool.....the base.....

Michael Brady

That stool is going to be super-nice. If you are able to get that walnut billet, I would like to do the same and make my own, if you wouldn't mind the imitation.

Re: THE Shop Stool.....the base.....

#5

Re: THE Shop Stool.....the base.....

roger lance

Michael.....I got an 8/4 cherry board today from my hardwood supplier.....the walnut still was not ready to come from the kiln.....so it will be a cherry seat and hard maple base.....imitation is the highest form of flattery they say.....and I'm imitating various stools I've seen.....so have at it. The main reason I was interested in walnut was to have the stool somewhat match my bench base which is hard maple with walnut stained panels on the ends and back of the base.....which you can sort of see here.....


Maybe, I'll still hold out for some walnut.....maybe call that supplier tomorrow and see.