Anyone do face frames in plano clamp?
David Weaver
Just curious, I don't have a plano setup and I'm guessing most folks just lay out a face frame on a layout table.
It seems to me the ones that would fit in the width of the plano clamps could be done pretty easily with a couple of cauls.
I'm not thinking about figuring out the absolute best way to do them, I'm talking about a way that works well and is fast.
At the cabinet factory, everything in the entire place save a few door hinge machines and edge sanders was pretty much made either by the maintenance department or custom ordered tooling. So what I saw there does me no good.
(Yes, I realize that nearly none of the virtues of the plano setup are actually needed to glue face frames. Maybe an L shaped batten with surface clamps on a sacrificial table would be better).




